Electronics Forum | Mon Jun 27 12:02:47 EDT 2022 | proceng1
I have never used a VP oven, but I did get a pretty good demo of one and was pushing hard for my company to acquire one. The issue ended up being that there was not an East Coast distributor for the "juice" and that became cost prohibitive to get sh
Electronics Forum | Tue May 19 21:02:20 EDT 1998 | Steve Gregory
Hey there ya'll... I was reading the messages from Earl asking where he could upload some articles he wrote, and I was asked how one goes about putting a image in the messages here... Ya'll see down at the bottom where it says; "Optional Ima
Electronics Forum | Wed May 20 07:24:18 EDT 1998 | Earl Moon
| Hey there ya'll... | I was reading the messages from Earl asking where he could upload some articles he wrote, and I was asked how one goes about putting a image in the messages here... | Ya'll see down at the bottom where it says; "Option
Electronics Forum | Sun Aug 04 13:44:01 EDT 2024 | pradeep14
How to Solder SMT Capacitor on top of the Resistor (0805 package). Is their any method/suggestions to solder this component . Thanks in advance
Electronics Forum | Wed Aug 07 14:29:16 EDT 2024 | proceng1
I'm not sure that you could reliably automate it. So it's probably going to have to be a Hand Assembly operation. Maybe hand applying a drop of glue and hand placing the cap before reflow would secure them together so that someone with an iron could
Electronics Forum | Mon Jun 21 13:02:59 EDT 1999 | Earl Moon
| | | I dug through my big box of office crap and found the disk with my technical papers. I posted the one on process control in the SMTNet library. It covers a lot of ground on what causes defects in the wave (too much or too little of something)
Electronics Forum | Tue Oct 03 16:56:32 EDT 2000 | JAX
Not sure if I agree with your justification but I might need to read it a few more times to figure it out. I agree that aquiring a dispensing machine is is a good purchase. Maybe you should let him in on the material savings. How many adhesive stenci
Electronics Forum | Mon May 26 04:39:49 EDT 2014 | sarason
Damn near impossible. You need to see a real change in the difference between the 2 elements you are reading. So to give yourself any hope run 2 long traces one top one bottom up the length of the board. Then compare to 2 wriggly traces at one end (o
Electronics Forum | Thu Jun 07 16:33:15 EDT 2007 | mumtaz
Please, it does not matter the school from which it is you came, but what you learned from it that counts. It is simple mathematics my friends. Lets make things simple, shall we not? E=I/R..... this we all should know. We can use this to measure
| 1 |
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
