Electronics Forum | Fri Jun 03 04:16:27 EDT 2005 | Bryan She
Background: We use a thermal boards to setup/profiling the reflow oven for pilot run.and then daily verify the reflow profile with this thermal board.Now we phased into LF production,and the LF thermal board can only withstand 25~30 times reflow excu
Electronics Forum | Fri Jun 03 14:55:15 EDT 2005 | Bman
Both our Quad ZCR and our Conceptronic HVN-102 ovens have had blowers out with no alarms raised. We knew there were problems based on how boards were soldering, but don't count on your oven to tell you if anything is wrong with it. We verify once a
Electronics Forum | Fri Jun 03 09:00:06 EDT 2005 | russ
How many times have you found that your oven was performing differently? this will give you the answer on frequency. We have a dedicated board and profile that we use to verify the oven operation. We perform this every 3 mos. and I believe that th
Electronics Forum | Tue Jul 28 17:23:58 EDT 1998 | Robert Steltman
| | We are about to run our first BGA devices and would appreciate some confirmation on a few points. | | First some details: | | PCB & Device: | | ============= | | 1) 16 layer (4 power, 4 gnd, 8 signal) | | 2) gold on nickel finish | | 3) ceramic
Electronics Forum | Tue Jul 28 09:15:49 EDT 1998 | Justin Medernach
| We are about to run our first BGA devices and would appreciate some confirmation on a few points. | First some details: | PCB & Device: | ============= | 1) 16 layer (4 power, 4 gnd, 8 signal) | 2) gold on nickel finish | 3) ceramic BGA with eutec
Electronics Forum | Mon Jul 01 09:33:08 EDT 2019 | dbuschel
if you can't change the PCB materials or design at this point, you might be able to reduce it somewhat through the use of fixtures or edge stiffeners. Unless it is a particularly thick board, I don't think the reflow profile would be the issue. The t
Electronics Forum | Sat Jun 04 15:06:20 EDT 2005 | slthomas
After profiling with a scrap board of the product I'm profiling, I would immediately send the MOLE through with one thermocouple only, no board, to provide a standard that I could reproduce without depending on scrap boards. I used that setup before
Electronics Forum | Mon Jun 13 16:09:33 EDT 2005 | mrmaint
We verify ours once a month using our calibration board. You can use any board once your profile is set for a specific product. All you are doing is checking the performance and repeatability of the oven.
Electronics Forum | Fri Jun 10 12:11:49 EDT 2005 | chunks
QS and ISO can really play a part here. If so, the best way I found was to run parallel T-couple ports to the thermocouples of the oven. Now you can run a board and gather all your thermal information and set your temps. Now use parallel ports to
Electronics Forum | Mon Jun 13 15:22:36 EDT 2005 | peter ng
The correct Frequency to verify your reflow profile is about one week except when you replaced the part,equipment,the channel setting of the oven or running pilot lots.The period of the Themal board is around 50 times.
