Electronics Forum | Tue Feb 19 08:41:02 EST 2019 | prasanth
dear experts, i want your suggestion for getting a profile in Heller 1707 mk iii series re-flow machine ,its 7 zone machine recently we had a solder ability issues , so pls guide me ,how to set rts profile parameters
Electronics Forum | Tue Feb 19 12:28:26 EST 2019 | slthomas
Presumably you're talking about lead free, but you don't say. Heller can probably provide you with a starting point, as rob has already pointed out, but you do need to develop the capability to perform profiling yourself. That oven should have ECD
Electronics Forum | Tue Jul 28 17:23:58 EDT 1998 | Robert Steltman
| | We are about to run our first BGA devices and would appreciate some confirmation on a few points. | | First some details: | | PCB & Device: | | ============= | | 1) 16 layer (4 power, 4 gnd, 8 signal) | | 2) gold on nickel finish | | 3) ceramic
Electronics Forum | Mon Jun 13 15:22:36 EDT 2005 | peter ng
The correct Frequency to verify your reflow profile is about one week except when you replaced the part,equipment,the channel setting of the oven or running pilot lots.The period of the Themal board is around 50 times.
Electronics Forum | Mon Jun 13 16:09:33 EDT 2005 | mrmaint
We verify ours once a month using our calibration board. You can use any board once your profile is set for a specific product. All you are doing is checking the performance and repeatability of the oven.
Electronics Forum | Fri Jun 10 12:11:49 EDT 2005 | chunks
QS and ISO can really play a part here. If so, the best way I found was to run parallel T-couple ports to the thermocouples of the oven. Now you can run a board and gather all your thermal information and set your temps. Now use parallel ports to
Electronics Forum | Fri Jun 03 14:55:15 EDT 2005 | Bman
Both our Quad ZCR and our Conceptronic HVN-102 ovens have had blowers out with no alarms raised. We knew there were problems based on how boards were soldering, but don't count on your oven to tell you if anything is wrong with it. We verify once a
Electronics Forum | Fri Jun 03 04:16:27 EDT 2005 | Bryan She
Background: We use a thermal boards to setup/profiling the reflow oven for pilot run.and then daily verify the reflow profile with this thermal board.Now we phased into LF production,and the LF thermal board can only withstand 25~30 times reflow excu
Electronics Forum | Fri Jun 03 09:00:06 EDT 2005 | russ
How many times have you found that your oven was performing differently? this will give you the answer on frequency. We have a dedicated board and profile that we use to verify the oven operation. We perform this every 3 mos. and I believe that th
Electronics Forum | Tue Aug 13 13:46:54 EDT 2002 | soupatech
Hello again.... I have been reading up on profiles and how to set them up for different results. I now have an upcomming job with some strict guidlines on reflow. I was wondering... if I were to email a pic of my desired profile could someone out the
