Electronics Forum | Sat Dec 18 08:23:33 EST 2010 | remullis
I experienced warpage on a 7'x 13" long board, unfortunately my oven does not have center support. I use stiffeners on both of the short ends. It fixed my problem. Some of the things I was experiencing with the warpage on the second pass were placem
Electronics Forum | Fri Nov 07 23:40:41 EST 2008 | padawanlinuxero
I have been working on the SMT area for a while now, must of my experience is on programming and pick and place, now in my new job I have to control a complete SMT line and I have a little knowledge on working with solder paste but I like to read mor
Electronics Forum | Sat Oct 09 03:45:34 EDT 1999 | Brian
| Right now,we have some problem on SMT. Cause of the flux residue | in the connector. Do somebody have the same symptom? By the way, | can i find something to make the flux observe easy or take a photo with the flux. | | | Unfortunately, this pr
Electronics Forum | Mon Dec 06 06:06:44 EST 1999 | Glen brian
Recently, my plant met the problem of bridging, a metallic link, lying on the solder mask and joining nearby joints. It is very diffcult to observe by our inspector and may be only discovered with ICT testing. This defect ocurrs randomly around the
Electronics Forum | Mon Jul 08 22:03:39 EDT 2019 | eddy2019
Many beginners do not know how to start learning hardware circuits. In fact, the "hardware circuit" is composed of a part of the "unit module circuit". The so-called "unit module circuit" includes: various regulated power supply circuits (like the LM
Electronics Forum | Mon May 11 16:23:08 EDT 2009 | jorge_quijano
Yes, this is for a double sided board, (bottom) the issue is that the board has a lot af hand ion components before wave soldering, and some components are falling off within this process, even if I hit the 0603s with my finger It falls.
Electronics Forum | Mon Jan 21 06:58:41 EST 2019 | kiransahu
Without PCB layout, not much would get done. It is a ubiquitous need across industries; Industrial, consumer, military...Everywhere you look, there are chips soldered to PCBs to create a final product for the end customer. But where did we all learn
Electronics Forum | Tue May 23 09:01:21 EDT 2000 | Wirat S.
Dear all friend, I found problem of soldering bridging between SMT Chip terminal & Glue , but under the chip body. My process was double side SMT assembly with bottom side adhesive & heat curing, then wave soldering with water soluble flux (OS type)
Electronics Forum | Thu Jun 08 01:46:00 EDT 2023 | camilleyang3
To prevent BGA (Ball Grid Array) issues related to SMT (Surface Mount Technology) solder resist when fabricating a PCBA (Printed Circuit Board Assembly), you can follow these guidelines: Design considerations: Ensure proper spacing between BGA pads
Electronics Forum | Wed Nov 11 10:08:38 EST 1998 | Magnus
| | Hi, | | We are having problem with yield loss due to electrical fail. Further investigation shows that the failure is due to solder bridging under BGA. Has been there any study or experience on how this could occur and what we can do to prevent
