Electronics Forum | Sat Dec 18 08:23:33 EST 2010 | remullis
I experienced warpage on a 7'x 13" long board, unfortunately my oven does not have center support. I use stiffeners on both of the short ends. It fixed my problem. Some of the things I was experiencing with the warpage on the second pass were placem
Electronics Forum | Thu Jan 18 12:07:52 EST 2007 | tonang
How to problem solved about production reject IC short? Please advice us about setting screen mask printer, stering solder paste, profile reflow etc Thank you for your attention and cooperation Best regard, Tonang
Electronics Forum | Sat Oct 09 03:45:34 EDT 1999 | Brian
| Right now,we have some problem on SMT. Cause of the flux residue | in the connector. Do somebody have the same symptom? By the way, | can i find something to make the flux observe easy or take a photo with the flux. | | | Unfortunately, this pr
Electronics Forum | Mon Nov 21 09:23:06 EST 2005 | Amol
With a BGA, how much solder paste are you putting on the pads? sometimes, bridging occurs when there is more solder paste than needed during reflow.....just a thought
Electronics Forum | Tue Dec 06 06:14:38 EST 2005 | bwet
Try using some of those new polyimide stencils. They are 8mils thick and can prevent shorting if it is due to solder mask problems or too much paste. http://www.solder.net/technical/tips.asp BWET
Electronics Forum | Wed Nov 23 07:39:14 EST 2005 | chunks
Shorted to the sheild or the BGA balls are shorted? Sheilds move a lot during reflow. If this is the case, place some adhesive or peelable solder mask on either side of the shield and baords to stop it from moving.
Electronics Forum | Fri Nov 25 09:31:56 EST 2005 | davef
pyramus, First, search the fine SMTnet Archives for previous discussions on BGA shorts. Second, we're still not clear on the issue. * Is the problem with a BGA? If so, please describe the BGA, including any heat spreader * Is the problem with a uB
Electronics Forum | Tue Nov 22 10:12:13 EST 2005 | stepheniii
Have you complained yet to MuRata? You are talking about the same bluetooth module, aren't you. I hope everybody having trouble with module complains to them. I don't believe they put all the cautions and warnings about reducing the deltaT on the da
Electronics Forum | Thu May 26 08:52:42 EDT 2011 | davef
Phil Zarrow wrote a useful paper that could help in evaluating paste. Here read it ... Evaluating Solder Paste � Not An Option Contributed by Phil Zarrow of ITM an Independent SMT consulting firm With soldering being the dominant source of assembly
Electronics Forum | Wed Nov 17 00:59:33 EST 1999 | Gyver
Hello all, Recently we changed the vendor of flux. However, we would like to know in detail about how to qualify the new flux. Are there any procedures or standards to follow? Please help us to solve this problem by providing your knowledge and exper