Electronics Forum | Fri Oct 01 06:28:08 EDT 2004 | Dolby Laboratories
From time to time, component suppliers decide to discontinue production of components that we use in our products. Occasionally, these components can be sourced elsewhere or designs adapted or altered to accommodate alternates. In many cases, however
Electronics Forum | Mon May 02 18:54:28 EDT 2005 | MikeaJ
The answer you are looking for is part of your initial setup of the board and stencil. This information is to be found in the PCB setup menu/icon. The reason why the stencil loading pins are impacting the frame is because the default setting of the s
Electronics Forum | Wed Feb 10 12:52:21 EST 1999 | Dick Casagrande
|I'm getting in a little late on this but my 2 cents is: We have been using no-clean flux for a few years now but up till last month were still cleaning (the white residue) our boards (all thru hole). Finally did some investigation and found the flux
Electronics Forum | Thu Sep 30 07:03:05 EDT 1999 | Scott Cook
| Hi everyone, | | Greetings! | | I�ve got a 2-layered through-hole PCB�s having the following problems: | | Solder Mask peels after wave soldering at random locations and only at the bootom side of the PCB | Insufficient Solder and some solder ne
Electronics Forum | Tue Sep 15 19:54:13 EDT 1998 | Wayne Bracy
| Dear Dynapace and those who responded: | Sorry we were not quick enough to delete this ad. However, this gives us a chance to discuss with both users and vendors on ways to facilatate the desemination of product informtion other than via the Forum
Electronics Forum | Wed Sep 18 12:31:16 EDT 2002 | dragonslayr
My suggestion is to conduct a Design For Manufacturing (DFM)study on the assembly in question. Pay particular attention to the pad sizes, component lead dimensions and satisfy yourself that those two factors are correct. Given that pads match compone
Electronics Forum | Wed Nov 18 11:03:45 EST 1998 | Scott Lolmaugh
| | | | Does sombbody know what DPM rate a good and reliable SMT assembly line (incl. solder paste print, assembly and feflow soldering) has? | | | | DPM is Defects per million, usually measured on components. We run a process consisting of small to
Electronics Forum | Thu Nov 19 09:01:00 EST 1998 | Dave F
| | | | | For some as yet unkown reason, we have started to have some boards sag and go under the wave. The boards are surface mount top side and conventional components wave soldered. We have checked the wave hight and both the profiles on the wave
Electronics Forum | Thu Nov 19 08:20:04 EST 1998 | Earl Moon
| | | | For some as yet unkown reason, we have started to have some boards sag and go under the wave. The boards are surface mount top side and conventional components wave soldered. We have checked the wave hight and both the profiles on the wave so
Electronics Forum | Thu Aug 05 13:03:35 EDT 1999 | Dave Weihrauch
| | | | Has anyone out there tried to parylene coat plastic parts prior to soldering them to a pcb? I'm looking at several potential applications where fewer than 5% of my components on a pcb are plastic, yet from a reliability aspect (environmental