Electronics Forum | Thu Apr 10 18:42:03 EDT 2025 | tey422
Have you ran the hydra head calibration on all 8 heads? If you did but still having similar issue, then you might have a slightly bent hydra tool(s).
Electronics Forum | Fri Apr 11 18:23:56 EDT 2025 | cyber_wolf
Yes I can give you the answer. The Hydra head is a machanical/electrical unreliable turd. I had these at my previous job and saw minimally 4 Hydra heads get replaced under warranty. I wont even go into the "Midas" head or the linescan cameras or th
Electronics Forum | Thu Apr 10 14:29:57 EDT 2025 | babe7362000
I was wondering if anyone could tell me why only heads 6 and 8 are placing parts incorrectly? It does not matter which nozzles I use; it will randomly place them off. Right now, I have both heads disabled. I am not sure what to start checking.
Electronics Forum | Sat May 04 11:24:08 EDT 2013 | amelby
Hi, I have been having a problem with my My19E's hydra. The machine comes up with an error "Failed to locate HYDRA tool reference marks" and stops running. It does not happen for about the first two hours of running. It starts to happen after that an
Electronics Forum | Tue May 07 09:20:43 EDT 2013 | dontfeedphils
That may have fixed it, but it doesn't sound like that would be the original cause.
Electronics Forum | Mon Jun 15 17:54:38 EDT 2015 | catsem23
Hi I have been having a problem with my Hydra tool reference plate. Machine keeps stopping and comes up with error message - failed to locate hydra tool reference marks & Error mounting component .... from feeder ..... with nozzle .... I have check
Electronics Forum | Wed May 08 11:20:24 EDT 2013 | amelby
Thanks for the info on the Hydra tubes that will be helpful. I found the answer from one of the Mydata techs. The Camera needs the hydra head to go slower then 1.9m/sec and the setting was at 1.8m/sec. They found out that even if the machine was set
Electronics Forum | Mon May 06 11:16:07 EDT 2013 | rdubya
if you don't have anything obstructing the camera then it sounds like it could be the camera power supply going bad. what version of tpsys are you running?
Electronics Forum | Mon May 06 11:24:04 EDT 2013 | amelby
Hi, Thanks for the help, The software on the Mydata is at least 2.9 I just had it upgraded last year. Arnie
Electronics Forum | Thu Jun 25 12:11:03 EDT 2015 | island2013
Let us know how it goes. We offer Mydata support and parts should you need it. http://www.islandsmt.com
