Electronics Forum | Mon May 31 11:08:28 EDT 2010 | padawanlinuxero
Hello I am having problems with the hydra camera, I start getting an error message saying that the camera couldnt look at the fiducials on the hydra, I went to the camera in service and turn it on to see the problem but I found out that the real pr
Electronics Forum | Thu Mar 28 16:51:00 EDT 2024 | tey422
Since you only saying it's the hydra error, then only run the hydra calibrations. Sometime the calibration can end up causing more issue if not run it correctly. I would do the hydra camera Z level (1st). If it fixes the issue then you no need to do
Electronics Forum | Thu Mar 28 16:11:12 EDT 2024 | kingkelvin
In calibration menu - I see coarse measurement of z unit offset, z-unit offset, measure hydra camera z level, coarse adjust hydra tool offsets, and measure hydra tool lengths 1 - 8 - would it be any of these that I should run?
Electronics Forum | Thu Mar 28 14:28:26 EDT 2024 | kingkelvin
We have MY9 - when it changes hydra tooltips - most of the time it makes a small "hitting" type noise - with error F-MOT MOVESLOWMOVE HYDRA Z/205 - however you can just hit continue and it will always change the tools and finish the board - I've un-i
Electronics Forum | Thu Mar 28 18:00:31 EDT 2024 | alexv
The tapping noise is what you hear when Hydra taps each tool on the tool bank to make sure the tips are seated well. The error is a Z-motor problem. The gear is at the top of the Hydra and needs grease. Have you cleaned the old grease and applied new
Electronics Forum | Thu Mar 28 17:13:11 EDT 2024 | tey422
It's been long time, me memories are fading away. If I remember correctly, you would need small flat surface plate or something to cover up the "linescan" hydra camera, so from the reflections value then it can calculates the actual height "lowest"
Electronics Forum | Mon Apr 08 14:07:25 EDT 2024 | kingkelvin
Hello all - so I got in the calibrate plate for hydra tool offsets - it completed the calibration - I then installed the first row of white tips with the menu - and the machine still does same thing it puts the tips away but makes a hitting type nois
Electronics Forum | Mon Apr 08 15:07:56 EDT 2024 | tey422
To me, it seems like there are slightly XY offset. Hydra might be able to pick up the tips, but not all the way securely attached to the hydra tubes. So, when the tips put back are not fully seated, which causing the tool stick inside the bank. You
Electronics Forum | Tue Apr 02 15:03:45 EDT 2024 | tey422
I believe you need one of this https://www.pfipartsus.com/products/mydata-l-019-0633-1
Electronics Forum | Mon Nov 28 14:05:02 EST 2011 | cyber_wolf
Negative on the spares. Mydata wants the other head for core....
