Electronics Forum | Tue Dec 06 18:35:21 EST 2022 | cyber_wolf
Sounds like the Hydra is disabled in settings. One of the Micronic experts will have to tell you where that is.. My last Hydra was a MY12 many years ago.
Electronics Forum | Fri Sep 02 10:14:18 EDT 2005 | Mity-C
Hi, We have done many 0402's with Hydra. We have done 0201's with the single head on Linescan but have yet to actually run them on Hydra. We now have a machine equipped to do this with the corresponding hydra tips. I will update as soon as I have an
Electronics Forum | Mon Apr 08 14:07:25 EDT 2024 | kingkelvin
Hello all - so I got in the calibrate plate for hydra tool offsets - it completed the calibration - I then installed the first row of white tips with the menu - and the machine still does same thing it puts the tips away but makes a hitting type nois
Electronics Forum | Mon Apr 08 15:07:56 EDT 2024 | tey422
To me, it seems like there are slightly XY offset. Hydra might be able to pick up the tips, but not all the way securely attached to the hydra tubes. So, when the tips put back are not fully seated, which causing the tool stick inside the bank. You
Electronics Forum | Thu Mar 28 18:00:31 EDT 2024 | alexv
The tapping noise is what you hear when Hydra taps each tool on the tool bank to make sure the tips are seated well. The error is a Z-motor problem. The gear is at the top of the Hydra and needs grease. Have you cleaned the old grease and applied new
Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t
Electronics Forum | Tue Apr 02 14:56:30 EDT 2024 | kingkelvin
Hi all - my problem is a bit worse now - I can get all hydra tests to pass in extended service, except indicator levels at current 7 a bit high past 190 limit at ~210-220 - other than that hydra bank re-installs OK - but still it makes a bad hitting
Electronics Forum | Tue Aug 09 13:58:24 EDT 2005 | Cmiller
I saw a Mydata demo and it seems like it would be pretty easy to pull a magazine back a few inches then tip it up into the head. I assume this would cause catastrophic damage. I was told this has never happened in North America. Which means it must h
Electronics Forum | Thu Mar 28 15:18:21 EDT 2024 | tey422
From the error message, might have to do with the "Z"-axis. You didn't mention you redo the calibration or not, then you should run that too. My guess would be "Z reading maybe slightly off". BTW, last time I work with those Mydata machine were bac
Electronics Forum | Fri Oct 16 21:33:51 EDT 1998 | Scott
| I do not think that the Mydata can pick from wafer or has the accuracy required (12 micron)! Am I missing something? I don't have personnal experience with flip chip but the next time you're at Nepcon ask Mydata to show you their demo board with
