Electronics Forum | Fri Jan 19 05:46:59 EST 2018 | ivammendes
MYDATA MY9E: Hydra's pipe can't stop the vacuum during assembly. The problem ocurre just in only one pipe, the number 5. The tool picks components but doesn't drop it. Can the problem be in the unit vacuum?
Electronics Forum | Fri Jan 19 08:23:26 EST 2018 | ivammendes
Our supplier said the same. I thought it could be anything more simple. Anyway, he will send me another block to replace and see if works. Thank you for answer.
Electronics Forum | Fri Jan 19 09:36:06 EST 2018 | emeto
In my opinion save the old block and see how hard is to replace one if you have problems in future. I suppose it will be fixable.
Electronics Forum | Fri Jan 19 08:10:03 EST 2018 | emeto
It should be one of these latches that got stuck in position. I had a similar problem(my200 machine) the other way around - my stays closed so I don't get any vacuum. The problem is that the whole block of latches should be replaced(on a my200 machin
Electronics Forum | Wed Jun 17 01:02:16 EDT 2015 | armandogomez
Hello Had a similar problem way back with the hydra, first go to the service program manually activate the hydra camera then move the Xwagon to place the hydra ref plate over the hydra camera and check first if the camera works, second the image you
Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t
Electronics Forum | Sat May 04 11:24:08 EDT 2013 | amelby
Hi, I have been having a problem with my My19E's hydra. The machine comes up with an error "Failed to locate HYDRA tool reference marks" and stops running. It does not happen for about the first two hours of running. It starts to happen after that an
Electronics Forum | Wed May 08 11:20:24 EDT 2013 | amelby
Thanks for the info on the Hydra tubes that will be helpful. I found the answer from one of the Mydata techs. The Camera needs the hydra head to go slower then 1.9m/sec and the setting was at 1.8m/sec. They found out that even if the machine was set
Electronics Forum | Tue May 07 09:20:43 EDT 2013 | dontfeedphils
That may have fixed it, but it doesn't sound like that would be the original cause.
Electronics Forum | Mon Jun 15 17:54:38 EDT 2015 | catsem23
Hi I have been having a problem with my Hydra tool reference plate. Machine keeps stopping and comes up with error message - failed to locate hydra tool reference marks & Error mounting component .... from feeder ..... with nozzle .... I have check
