Electronics Forum | Fri Jan 19 05:46:59 EST 2018 | ivammendes
MYDATA MY9E: Hydra's pipe can't stop the vacuum during assembly. The problem ocurre just in only one pipe, the number 5. The tool picks components but doesn't drop it. Can the problem be in the unit vacuum?
Electronics Forum | Fri Jan 19 08:23:26 EST 2018 | ivammendes
Our supplier said the same. I thought it could be anything more simple. Anyway, he will send me another block to replace and see if works. Thank you for answer.
Electronics Forum | Fri Jan 19 09:36:06 EST 2018 | emeto
In my opinion save the old block and see how hard is to replace one if you have problems in future. I suppose it will be fixable.
Electronics Forum | Fri Jan 19 08:10:03 EST 2018 | emeto
It should be one of these latches that got stuck in position. I had a similar problem(my200 machine) the other way around - my stays closed so I don't get any vacuum. The problem is that the whole block of latches should be replaced(on a my200 machin
Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t
Electronics Forum | Fri Mar 24 11:28:10 EDT 2023 | cyber_wolf
We replaced at least 4 Hydra heads, 3 midas heads, vacuum pumps, line scan cameras under warranty back in the day. I have worked with Juki 2060 and 3010 series. Whomever is telling you they are bad machines doesn't know.
Electronics Forum | Fri Feb 21 17:12:43 EST 2020 | SMTA-Alex
Have you performed the maintenance? It might need grease, or there might be excess old grease, that's putting more friction on the Hydra Z. Check if there might be interference from the vacuum tubes or wires.
Electronics Forum | Tue Jul 17 09:10:28 EDT 2012 | dontfeedphils
You can enter the service program for the MyData, can't remember exactly how, you have to exit out of tpsys to the command prompt and type service or something along those lines. Then you can check the raw numbers for vacuum and force on the Midas h
Electronics Forum | Wed Sep 11 18:01:27 EDT 2013 | huske
I've had that issue before, here's how you fix it, or at least it worked for me. Also assuming you didn't destroy a shaft, which should be obvious. Follow the flexible vacuum tubes to the top of the hydra shafts, you should see a red light below the
Electronics Forum | Thu Feb 06 20:23:35 EST 2020 | bilalfarooqi
Hey everyone, We use a MyData MY12 machine and we are experiencing a problem with the Midas head. I recently replaced a torn vacuum tube that goes on the zfib card. The machine worked perfectly for a day and a half but now MY12 has completely stoppe
.gif)
winsouce.jpg)
