Electronics Forum | Sat Feb 22 09:47:44 EST 2020 | tomdegas
When I run the "Service" software and I look at the status of the HYDB in the Utilities tab, it comes back with all is good except that the Hydra motor temperature sensor is "disconnected". Can anyone tell me where this sensor is and is it replaceabl
Electronics Forum | Mon May 09 19:24:53 EDT 2022 | rgduval
It's been a minute...but, does the My9 still have MOT boards in the computer cage? If so, swap the MOTz with the MOTx or MOTy, and see if the problem moves. If so, replace the motor controller board. If not, +1 on the encoder or Z-motor. Check fo
Electronics Forum | Mon May 09 19:00:47 EDT 2022 | SMTA-64387687
Z-force sensor is a tool travel indicator. It has nothing to do with Z travel. Does the Midas head move at all, during initiation? It sounds to me like a Z motor/encoder problem. Is the Midas head ribbon cable plugged in?
Electronics Forum | Fri Aug 30 11:31:29 EDT 2013 | nophsem
We have two QUAD 4C working in tandem. 3 months ago the EPCU battery (QUAD # 2) died, then we change it. Then downloaded the MODs from the controller to the assembler(does simultaneously on both machines). All this time we continue to work normally.
Electronics Forum | Fri Aug 30 05:34:28 EDT 2013 | bobpan
I would check the following: 1. Make sure the head can move in all axis including z and theta by physically moving each. 2. Check the voltage from the main power supply which is located in the middle of the machine on the top of the main board asse
Electronics Forum | Mon Jun 19 11:16:22 EDT 2023 | eurolan
Hi guys, we managed to fix it. This tool turned out to be impossible to find. What we did is mount the motor, mark the timing belt's position and loosen the screws that attach the timing belt to the head. This way we were able to move the position of
Electronics Forum | Mon Jun 12 11:14:10 EDT 2017 | bobpan
Sounds to me like the z-encoder could be a problem. I cant remember but you may be able to disable a head in the system settings. Bob
Electronics Forum | Wed Jan 23 07:42:34 EST 2019 | rolfi
Hi, we had the same issue with our CP30V and head1. Did you solve the problem? Please let me know as well. Thank you.
Electronics Forum | Thu Jan 24 09:09:46 EST 2019 | protokos
Hi Kathy i had the same issue yesterday and find that a spring is not ok. and i also clean the sensors this was fixing the problem for me.
Electronics Forum | Tue Mar 04 17:17:29 EST 2014 | catsem23
Hi I'm trying to pick and place a lot of sod523 components with a mydata my12. I'm using C14 standard tool and Hydra tool H01. For some reason no matter what I try to do when the head picks the component with the C14 tool the machine emergency stops
