Electronics Forum | Mon May 31 11:08:28 EDT 2010 | padawanlinuxero
Hello I am having problems with the hydra camera, I start getting an error message saying that the camera couldnt look at the fiducials on the hydra, I went to the camera in service and turn it on to see the problem but I found out that the real pr
Electronics Forum | Fri Jan 12 11:04:09 EST 2007 | mika
zero > in manual Control > bring the head close to the end of the machine so that you can reach the head => Diagnostic meny > engage the clutches and THIS IS VERY IMPORTANT: use Extreme Caution (you can flip off the X-Y circuit braker on the lower ba
Electronics Forum | Wed May 04 19:38:57 EDT 2022 | mikevb
I have a used MyData My9 machine that I've picked up recently and it has a problem with initializing that I can't figure out. It just gives an error stating "no z indicator value at all". I've replaced the flex board with the force sensors but that d
Electronics Forum | Mon May 09 19:00:47 EDT 2022 | SMTA-64387687
Z-force sensor is a tool travel indicator. It has nothing to do with Z travel. Does the Midas head move at all, during initiation? It sounds to me like a Z motor/encoder problem. Is the Midas head ribbon cable plugged in?
Electronics Forum | Mon May 09 19:24:53 EDT 2022 | rgduval
It's been a minute...but, does the My9 still have MOT boards in the computer cage? If so, swap the MOTz with the MOTx or MOTy, and see if the problem moves. If so, replace the motor controller board. If not, +1 on the encoder or Z-motor. Check fo
Electronics Forum | Tue Mar 04 17:17:29 EST 2014 | catsem23
Hi I'm trying to pick and place a lot of sod523 components with a mydata my12. I'm using C14 standard tool and Hydra tool H01. For some reason no matter what I try to do when the head picks the component with the C14 tool the machine emergency stops
Electronics Forum | Wed Mar 31 10:08:13 EDT 2010 | leemeyer
First I would only be concerned about the front panel led's if the transport is not clamping. These LED's are most likeley burnt out. If the transport clamps your sensors are working properly. If you are seeing a "Place 1 Z" on the handheld it is ask
Electronics Forum | Wed Mar 05 10:02:47 EST 2014 | dyoungquist
Per the TPSys Version 2.4 Software Manual: Force sensor level not within limits. * Force sensor dirty (inside Z tool holder) * Bad force sensor connection Try this: Remove the tool from the Z Midas head. Take a cotton tipped applicator (Q tip) and
Electronics Forum | Wed Mar 31 11:33:19 EDT 2010 | gantry228
Also, ensure you have taught the pickup and have the part on the nozzle when teaching the placement Z height.
Electronics Forum | Wed Mar 31 06:08:45 EDT 2010 | miroyu
Hi everyone ! I started to program quad 4C for the first time and have some problems. First, board detection LED and proximity Led (on the front panel) are not lightning whatever I do! Second problem is I teach machine board size, nozzle locations
