Electronics Forum | Thu Nov 11 18:39:06 EST 1999 | John Thorup
Assuming that you are going to solder them into a board rather than socket them, yes. The thickness of the gold plating in this application will usually make up a large enough percentage of the total joint to threaten enbrittlement. Use a small sol
Electronics Forum | Fri Nov 12 16:59:58 EST 1999 | John Thorup
Hi Michael While driving home last night I realized the omission in my response. I thought someone would call me on it. I should have clarified that the dissolution of the gold into the joint would be affected by the thickness of the gold plating,
Electronics Forum | Fri May 28 17:44:51 EDT 1999 | Glenn Robertson
| I discovered that we have some gold plated (30 mico in.) through hole connectors which were Paste In Hole soldered (60 sec at reflow) on a HASL PCB. Do we have an embrittlement reliability issue? The calculated volume % of gold in the joints is abo
Electronics Forum | Fri May 28 17:30:35 EDT 1999 | Dave Clements
I discovered that we have some gold plated (30 mico in.) through hole connectors which were Paste In Hole soldered (60 sec at reflow) on a HASL PCB. Do we have an embrittlement reliability issue? The calculated volume % of gold in the joints is about
Electronics Forum | Fri Jun 03 15:19:32 EDT 2022 | dwl
I don't recall thicknesses off the top of my head but brittleness becomes an issue more for gold plating then ENIG. .125 um should be fine. also, gold ain't cheap so its unlikely your PCB fab will get anywhere near the max tolerance. On the other e
Electronics Forum | Wed Jun 08 23:04:26 EDT 2022 | SMTA-64387544
Au thickness of 0.125 um should not cause solder joint embrittlement. Also, PCB fab should offer Au thickness range between 0.05-0.075 um for better process control and reliability. Higher Au thickness may suggest black pads leading to solder joints
Electronics Forum | Sun Apr 15 23:35:14 EDT 2007 | Sam
few more questions: Is there any standard saying that the dull surface is accepted if solder Au plated leads? Understand that more than 3% Au in the solder connection leads to unacceptable embrittlement of the connection. How about any standard relat
Electronics Forum | Tue Jun 13 08:17:06 EDT 2006 | davef
The solder alloy does not change based on the flux. Your potential for embrittlement is the same [providing the metal of the solders are the same] with either solder. We would guess the OA flux is [and drag tinning are] removing corrosion from the
Electronics Forum | Mon May 12 22:40:19 EDT 2003 | nyazga
I have always heard to use solder with 2 percent silver to reduce gold embrittlment. One vendor site said this is a myth. Does anyone know of a specific document recommending this such as IPC or MIL spec. ???
Electronics Forum | Mon May 06 12:20:09 EDT 2013 | davef
Gold in solder alloys can be brittle. We always used to talk about keeping gold LT 3% in order to avoid embrittlement. Some military contracts require removal of gold from soldered contacts. Adding gold to a solder alloy that you're familiar with wi
