Electronics Forum | Mon Oct 08 03:53:08 EDT 2007 | d0min0
Hi, we do stepper motor assembly, and "use" both methodes; coil is selective soldered before entering line and then coils & I/O connector are soldered to PCB with robot (in many points also manual soldering) regards Dominik
Electronics Forum | Thu Mar 12 21:14:16 EDT 2009 | davef
Mask: * I/O connector contact surfaces * Bus connector contact surfaces * Configuration jumper blocks * Test points * Surfaces that contact heat sinks (heat sinks are removed prior to coating) * Board mounting holes * Adjustable potentiometers * P
Electronics Forum | Mon Dec 04 14:21:49 EST 2006 | jdengler
Todd, It's been a while since I have looked at this but I believe the IP-1 does not have a relay board for the feeders. +24 Vdc is wired to a pin on the connector and the I/O board (NO 3 I think) switches the ground. If you don't have +24 Vdc at 1
Electronics Forum | Tue Feb 02 17:00:50 EST 2016 | warwolf
Hello, We are currently having a problem with the output of the cameras in our SM421, the fault we are seeing is a flickering across only the 6 flycam cameras (this is causing SM vision to not correctly reference the parts) We have tried: Swapping t
Electronics Forum | Wed Jan 19 13:30:37 EST 2011 | bvdb
The user manual says: Cause: A stick feeder part shuttle is in the advanced position where it could interfere with the nozzle. Remedy: Press the [I/O] function key and retract the part shuttle. I don't have a stick feeder. I tried resetting the I
Electronics Forum | Wed Oct 20 11:14:55 EDT 2010 | swag
I hope you're fixed by now but my advice is to pull all connectors from drivers and reseat. Also, reseat connectors in I/O area + I think there's some cards that relay power to various axis in this area. Reseat all connectors. From my experience,
Electronics Forum | Tue Feb 21 10:45:45 EST 2012 | acsscott
Thanks for the password. There is a 7 pin connector for the Emergency stop in and out. It has a mate with a jumper wire attached to the Topaz end. If you put the jumpered mating connector on this, the emergency stop errors go away. The other conn
Electronics Forum | Wed Jan 20 16:26:34 EST 2021 | ttheis
Low Air Pressure: System reporting low air pressure; verified 12Vdc at pneumatic panel, manually jumpered and verified connections back to GPIO1 connector on the LOC I/O assembly. Swapped LOC IO cards then entire LOC IO chassis, with another machine.
Electronics Forum | Thu Jan 20 07:58:46 EST 2011 | jdengler
Hi Bert, Take all feeders off of the machine. Do a reset start (hold reset switch in while powering up the machine). This will flush the memory so you will need to load PROPER, STATUS, PROGRAM. If it still does it you may have a short in a feede
Electronics Forum | Mon Apr 29 05:25:13 EDT 2002 | ianchan
Hi, we do Sn plated I/O pinning insertion into Ni/Au thru' holes. no problems here so far, as we cater for the "interference" (fit-allowances) of the I/O pin into the thru' diameter, via improved PCB thru' hole designs. before this cater/considerati
