Electronics Forum | Mon May 08 22:39:18 EDT 2006 | smartasp
I have read an interesting article on pip plus, where they say "However, both PIP processing and the use of solder preforms are well-proven methods. The combination of pin-in-paste plus solder preforms delivers numerous benefits compared to a combi
Electronics Forum | Tue May 09 09:15:34 EDT 2006 | Chunks
Yoinks. I'd look selective solder. Preforms are a pain, but try for yourself.
Electronics Forum | Mon May 15 14:13:51 EDT 2006 | Chunks
M'kay, "I" see now. Thanks for straightening me out on the PIP process guys!
Electronics Forum | Fri May 12 06:13:55 EDT 2006 | slaine
Hi I use a lot of preforms for other specific applications. Personally I like indiums product but the lead time is awful and dont often deliver them on schedule. (im in the uk). Some manufactures make preforms out of solder wire that is pressed flat
Electronics Forum | Tue Apr 14 08:13:08 EDT 2009 | kpm135
If you plan on loading offline to get the most out of your machine time every day then they are a must. If you don't care about that and how long your change overs keep the machine down then I guess they don't matter.
Electronics Forum | Mon Jan 20 05:15:21 EST 2020 | bobpan
Hello, You have a tep initialize issue. Please contact me. If you need my email go to my website and i would be glad to help. www.precision-repairs.com Bob
Electronics Forum | Fri Apr 16 15:12:12 EDT 2021 | jsmith01
Does anyone know where the power to the lambda, chip sensors comes from on a Electrovert EPK plus? I have an intermediate issue with these sensors loosing power and the wave just keeps going higher and flows over the pot. I have replaced the senors
Electronics Forum | Wed Jan 23 09:38:37 EST 2008 | brulal1
I would like to get statistic from SPC plus on regular basis, the problem is: Software is slow and freezing. The only stat I could get from it are general. The nigthmare start went we try to dig to find what cause the defect. It�s possible, but it ai
Electronics Forum | Tue Nov 29 12:44:53 EST 2022 | proceng1
I believe I had to use the back up copy of the SmartSM folder. One of the files was correpted.
Electronics Forum | Thu Mar 15 17:33:20 EDT 2007 | Darby
As you are new to this - start with lots of hair and slowly reduce. Start with one good person. Spend the money on someone who knows the process, can set it all up, (including air, power, alignment, calibration, programming, troubleshooting, stenc