Electronics Forum | Thu Jun 02 18:16:26 EDT 2005 | URI
Look into the Juki KE-2060E machine. I have been > extremely pleased with this machine. It will > hold 80-8mm feeders, place 0201 (0603-metric) up > to 74mm square ICs and BGA, 150mm long > connectors. Up to 25mm tall components. It can > ha
Electronics Forum | Mon Aug 12 06:40:20 EDT 2019 | agganitk
Hello, I am looking for I-pulse M1 or M2 service manual. If anyone has, please share.
Electronics Forum | Thu Jun 20 17:40:03 EDT 2002 | pjc
Depends on which Assembleon machine, aye? The "GEM" line, Topaz & Emerald, stuff is Yamaha- Japan, which I consider more along the lines of Juki and i-Pulse (Tenyru/Yamaha), and maybe Samsung. The "Power" line, ACM & FCM, on the other hand is pure Du
Electronics Forum | Thu Oct 02 06:26:57 EDT 2003 | loz
Hi all. Can anyone offer any feedback from prior experience of I-pulse M1 SMT mahcines. Usual stuff, ie capability strengths, weaknesses etc.Also any quirks in the platform? Thanks in advance. Loz
Electronics Forum | Wed Aug 27 07:00:38 EDT 2008 | tpradio
I doo have 2 similar M1 mashines... so that was my way to doo it allso....
Electronics Forum | Wed May 16 08:24:57 EDT 2001 | caldon
Davis- From my understanding Amistar does not sell SMT equipment any more. Tenryu(Amistars machine) is now IPulse. http://www.ipulse.co.jp/ENG/ This is right from Amistars web page "On April 1, 2000, Tenryu Technics was acquired by i�PULSE, a whol
Electronics Forum | Tue Jul 29 03:10:18 EDT 2008 | tpradio
I have a problem with a I-pulse M1. Monday morning i came back from vecation, and started up the machines. warmed them up, and then..... When i started the program, (normaly it starts with scaning the nozzles) the head moves to the first nozzle, and
Electronics Forum | Sat Dec 05 10:05:01 EST 2020 | tueftler
Oh, yes. You're right. I dont thought about trim service, too. But at the moment it is a HDD mounted. Maybe in the future...
Electronics Forum | Tue Dec 01 15:32:27 EST 2020 | spoiltforchoice
Could be your graphics card driver is set to output a resolution/refresh rate not supported by either monitor you tried. In that case XPs "Safe Mode" should use safe defaults just like it is doing when you see the loading bar. Another option is someh
Electronics Forum | Tue Dec 01 20:50:51 EST 2020 | tueftler
Hi there. Thank you for your reply. I have tested the VGA signal with two different VGA to VGA & HDMI converters without success. Now i have connect my oscilloscope onto the signal. RGB,V and Hsync...no signal at all after WinXP boot cycle. If i
