Electronics Forum | Thu Oct 10 17:32:52 EDT 2013 | soscomputer
you're right for sure, but there is some brand like hakko i don't like them why ? because process and menus (controllers) doesn't really give a good result. For example fm206, hot air/desoldering/soldering station doesn't have the real tc. And a lot
Electronics Forum | Thu May 01 17:38:06 EDT 2008 | ldbepurchase
www.ldbepurchase.com
Electronics Forum | Thu May 17 21:50:29 EDT 2007 | jeremyl
Hi All. We are a tiny startup company developing an IC in a flip-chip CSP package. We find ourselves in need of being able to remove and replace (ie rework) our chip on a characterization board. The board will not be big and the chip is very small
Electronics Forum | Thu Nov 16 23:34:56 EST 2006 | mds33200
Hi, I am new in this industry and have purchased a beguinner unut, a 3-in-1 solder, desolder, hot air station. Currently I work on cellphone mainboards. At the moment I only replace single large chips on the mainboard. I would like to be able to repl
Electronics Forum | Fri Jan 08 15:02:38 EST 1999 | Dave F
| HI! I am a package engineer in Korea. I have some reasons | to desolder excessive solder at the lead of TSOP and TSOJ | after removing them from the board. The way with solder wick is too time-consuming and depends on the operator. | Does anyone
Electronics Forum | Tue Mar 25 02:58:24 EDT 2014 | molder
ok.. thanks you so much.. I will buy new dispenser siringe, and I try to rework... I have a questions on desolder and solder a socket 1366 intel on motherboard. I have a rework station Honton hot air and tornado infrared, but i don't know a temperatu
Electronics Forum | Fri Jan 08 19:47:55 EST 1999 | Kwang-Seong Choi
| | HI! I am a package engineer in Korea. I have some reasons | | to desolder excessive solder at the lead of TSOP and TSOJ | | after removing them from the board. The way with solder wick is too time-consuming and depends on the operator. | | Does
Electronics Forum | Wed Sep 10 15:37:09 EDT 2008 | djmic
I just purchased a soldering station and it came with the silicone grease for the desoldering gun and say's for cleaning spring filter and filter pipe, now do I just smooth this grease all over the spring and tube the spring goes in?
Electronics Forum | Mon Jan 05 03:12:54 EST 2009 | lococost
If you can use a IR desoldering station, you could try covering the second BGA with aluminum tape. The tape shouldnt touch the second BGA, it should form a 'roof'over it that reflects the IR waves.
Electronics Forum | Fri Oct 03 16:22:38 EDT 2008 | alien
For plain old QFPs in small quantities, a temperature controlled heat gun + a decent soldering station can do the trick. In my case, Steinel HL 2010 E heat gun (handheld, but with a digital readout) to desolder. Clean up pads with solder wick. Solder
