Electronics Forum | Thu Jul 18 11:38:18 EDT 2024 | babe7362000
I am trying to figure out why the stacker goes up when you press the dump button. Then I have to lower it by hand to rehome. It then will rehome and go to where it needs to on the 1st slot.
Electronics Forum | Fri Jan 08 08:29:48 EST 2016 | ahanna
Water can be the issue. After Christmas break we came back to find a fair amount of water build up in our airlines for the building. I will check out the regulator as well as the solenoid. Thank you. I appreciate it.
Electronics Forum | Thu Sep 23 18:36:47 EDT 2010 | slwolbert
Have more info on the issue at hand. OS Error: CODE 0001 TASK 0029 PARA 0000 STAT 33E5 ADRS 00EF0000 INST 33F9 STRG 2704 PC 001449BE Hex dump on screen: 0000 FFFF F400 FFF7 BFD4 0090 BF63 FF7F FF71 FFFF DA73 FFED FFEB FFFF 6E4
Electronics Forum | Tue Sep 04 14:02:35 EDT 2018 | elsabudz
Hi Peter, I read your concerns regarding IC parts not packaged with desiccants and thought you may find our new Type 2 Humidity Indicator card of interest. Please visit https://www.clariant.com/type-2-humidity-indicator-card Thanks, Elsa
Electronics Forum | Thu Jan 08 16:16:09 EST 2004 | Dean
My first concern would be the choice of solder paste you have. There are better chemistries out there that far exceed the capabilities of the 609 2. Yes, the part will partially float on the solder (assuming plastic qfp). Cross sectioning would sho
Electronics Forum | Sat Aug 18 00:49:56 EDT 2012 | audere
When I see this on my QSP2 it is always caused by the nozzle not seating ideally but I tend to set my tolerances really tight. To test mount a nozzle and look at Z height. Now pick up the part (which in my case will suck the nozzle upward due to the
Electronics Forum | Thu Aug 16 07:40:27 EDT 2012 | bobpan
Here are a couple of things to look at. 1. Watch the machine run....and if it misses a part....make sure it doesnt blow out the next part being presented. Sometimes the air pressure is too high and the vacuum verify will blow the part out of the poc
Electronics Forum | Fri Jul 26 20:20:06 EDT 2019 | kylehunter
This week we assembled around 30 panels of a LED board, totaling around 350 boards. In doing so we had to work around a really crazy issue. 1) A board goes in, all components are placed perfectly. 2) Next board goes in, all components are around 5m
Electronics Forum | Thu Sep 02 13:19:52 EDT 2010 | remullis
I am having issues with the air dump on this machine. When you palm down or break interlocks the air dumps as it should however I'm getting a short burst of air back through the system. The problem with this is it's just enough to trigger the table l
Electronics Forum | Mon Jan 23 08:15:33 EST 2006 | pavel_murtishev
Good day, Vibratory (MultiStick) feeder is bottleneck of any placement machine. If you feed expensive IC�s via vibratory feeder they surely will be damaged. If you really care about expensive IC�s equip you placement machine with reject conveyor. In
winsouce.jpg)
