Electronics Forum | Thu Sep 24 07:14:39 EDT 2015 | mrnollid
What is the tolerance for inspecting a 28 pin IC in a socket? If it's not sitting flat to the socket, what height is acceptable?
Electronics Forum | Mon Oct 16 00:45:33 EDT 2000 | soza
Dear sir, I have a problem to find the new chemical solution instead IPA(isopropyl alcohol) to eliminate contamination on the test pin socket board made from copper that plate with nickle and gold. And after the often testing IC process, the co
Electronics Forum | Mon May 03 10:49:26 EDT 2010 | davef
What is the issue that you have when soldering IC sockets with vapour or reflow?
Electronics Forum | Mon May 03 01:56:56 EDT 2010 | aungthura
who's achieved in soldering to IC sockets with such machines, vapour or reflow? Hope he or she can share this success.Thanks in advance.
Electronics Forum | Thu Jan 23 04:16:58 EST 2003 | Archie
Hi Claudia! here you can find different kind of adapters. We�ve used some of them and those are working fine. Quite expensive, but... quality costs! http://www.e-tec.ch/IC_sockets_connectors.htm
Electronics Forum | Wed Aug 03 10:48:48 EDT 2005 | Rob
Connectors, IC sockets etc. have traditionally use a lot of recycled plastic in them. There are no guarentees that there are no PBB/PBDE's in them, so some manufacturers are having to change back to new plastics. So plastic goes in the ground i
Electronics Forum | Thu Mar 12 10:25:06 EDT 2009 | smt_guy
I have Through Hole Assembly Boards that require Conformal Coating but the customer did not specify which area or parts should not be coated. Upon asking them they are also not sure about it. I have Transformers, PLCC's on a socket, IC's on a Socket
Electronics Forum | Wed Apr 06 11:10:47 EDT 2005 | smt_rookie
We process a double-side reflow board (10 ups). Chips and IC's on the bottom side while chips, IC's plus thru-hole connectors and IC sockets on top side (bottom side first then top side reflow). In the past, we were not encountering any soldering pro
Electronics Forum | Sun Jun 17 09:37:41 EDT 2018 | sarason
The trick is to have the correct socket to place the IC into. Have the board permanently on the machine , place your IC run the attached programmer. pick up the IC and place back in the original or a new tray. Most SMT machines would be difficult to
Electronics Forum | Wed Sep 08 22:13:07 EDT 2004 | Frank
Our Juki KE-2020 can place up to 74mm X 74mm ICs and BGA. I am have placed this zif socket before on the KE-2020 that you are speaking of. I don't think the KE-2020s are being made any longer. I know the new KE-2060 machines (that replaced the KE-