Electronics Forum | Thu Sep 24 07:14:39 EDT 2015 | mrnollid
What is the tolerance for inspecting a 28 pin IC in a socket? If it's not sitting flat to the socket, what height is acceptable?
Electronics Forum | Wed Nov 20 21:30:36 EST 2019 | sssamw
first of all, you need check the strain caused by interference during connector insertion. If must done by SMT, then a claw would be better than nozzle.
Electronics Forum | Mon Oct 16 00:45:33 EDT 2000 | soza
Dear sir, I have a problem to find the new chemical solution instead IPA(isopropyl alcohol) to eliminate contamination on the test pin socket board made from copper that plate with nickle and gold. And after the often testing IC process, the co
Electronics Forum | Tue Aug 24 17:59:10 EDT 2010 | davef
A board support must be used to prevent bowing of the board during insertion of the sockets. It should have a flat surface with holes or a channel large enough to receive the sockets during installation. [Tyco AUGAT HOLTITE Socket Application Note 11
Electronics Forum | Sat Aug 21 15:02:32 EDT 2010 | jry74
I have a pcb with 750 plated through holes that get Holtite sockets inserted into them. I have a method of pressing in 10 sockets at a time. However, when we are done, the board has bad warpage on the X and Y axis. Does anyone out there have any t
Electronics Forum | Mon May 03 10:49:26 EDT 2010 | davef
What is the issue that you have when soldering IC sockets with vapour or reflow?
Electronics Forum | Fri Apr 24 11:00:36 EDT 1998 | Francisco Becerra
I have a problem with the insertion tooling of a 6241B VCD Insertion Machine. I must replace most of the parts of the insertion head but the screws of the Rails has the socket head damage, so it is not possible using the Allen Tool. I am looking for
Electronics Forum | Fri Apr 24 10:59:59 EDT 1998 | Francisco Becerra
I have a problem with the insertion tooling of a 6241B VCD Insertion Machine. I must replace most of the parts of the insertion head but the screws of the Rails has the socket head damage, so it is not possible using the Allen Tool. I am looking for
Electronics Forum | Tue Dec 12 11:29:02 EST 2017 | wesatitcpcb
We utilize socket receptacles, typical part number is 147444-1 from TE. These come to us loose and they have to be inserted to the PCB by hand. Does anyone know of a way to get these receptacles into the pick-n-place machine to automatically place
Electronics Forum | Wed Apr 06 11:10:47 EDT 2005 | smt_rookie
We process a double-side reflow board (10 ups). Chips and IC's on the bottom side while chips, IC's plus thru-hole connectors and IC sockets on top side (bottom side first then top side reflow). In the past, we were not encountering any soldering pro
