Electronics Forum | Thu Oct 03 15:46:15 EDT 2019 | compit
I have instructions "Manual CSM / GEM Illuminations Units" and "Manual Illumination System X-series" if it helps you ...
Electronics Forum | Wed Nov 17 03:58:18 EST 1999 | Bach Huss
Hi we are running S-15 here and the LED for the component camera is not all bringht at the same brightness level. This cause us to use different .gf for our standard component. It is hard to ballance the illumination level between machines. Does a
Electronics Forum | Fri Jun 07 10:55:33 EDT 2002 | Hussman69
You need an illuminance meter. We used these on the set of the Spice Girl videos. Search Yahoo for dozens of manufacturers. Use OSHA specs for setting up your factory - but aren't you in China? Not sure if they have an OSHA over there.
Electronics Forum | Mon Sep 22 12:21:10 EDT 2003 | dougt
You can use a meter in "diode mode" to illuminate an LED to check a batch. Hopefully your stock room doesn't open the container and poor them all into a bucket to be issued out to the floor.
Electronics Forum | Mon May 24 09:15:18 EDT 2004 | davef
Sounds bad. On measuring light intensity, look here: http://www.energybooks.com/pdf/D1150.pdf On color measurement, look here: http://www.qualitymag.com/CDA/ArticleInformation/Communities_Index/1,6427,65351-Color,00.html
Electronics Forum | Fri Jul 16 08:13:45 EDT 2004 | cyber_wolf
Can anyone give me a manufacturer name for a good quality illuminated SMT inspection magnifier. We use 3 diopter. I have tried many many different brands. They all seem to fall apart.
Electronics Forum | Fri May 30 09:50:04 EDT 2008 | jdengler
Another sticky issue is that if you use after market nozzles especially mixed in with Fuji nozzles the Anti-Marking Illumination Disks can be different enough that the vision system will reject nozzles. Jerry
Electronics Forum | Fri May 30 09:53:19 EDT 2008 | cyber_wolf
"Another sticky issue is that if you use after market nozzles especially mixed in with Fuji nozzles the Anti-Marking Illumination Disks can be different enough that the vision system will reject nozzles. Jerry " Thats what I meant when I said they
Electronics Forum | Fri May 30 11:58:16 EDT 2008 | fredc
The right paper incorrectly applied can be a problem also. I have seen it on even new Fuji nozzles with the illumination disk bunched up on one side of the tube with a gap on the opposite side.
Electronics Forum | Mon Jul 05 22:21:33 EDT 2010 | isd_jwendell
I have found that lighting for the cam is very important for fiducial recognition. My machine illuminates with a light ring, which isn't so good. However, if I burnish the fiducial with a small fiberglass brush then it works every time.
