Electronics Forum | Sun Aug 19 15:34:20 EDT 2007 | davef
What are you trying to do: * Improve hole fill? * Reduce PTH voiding? Hole fill: Search the fine SMTnet Archives for stuff like: http://www.smtnet.com/forums/Index.cfm?CFApp=1&Message_ID=36063 PTH voiding: Ideally, there are no voids. We're unawar
Electronics Forum | Sat Aug 18 11:23:10 EDT 2007 | Learn From U
Hi All, Via X-rays, we found solder voids appear on PTH location, especially on Dimm connectors area. We think this should be related to PCB issue as we found solder unable to fill up the PTH hole during bare board testing at wave soldering machi
Electronics Forum | Tue Feb 19 22:50:00 EST 2008 | amarpreet41
Do you of reducing hole size of DIMM connector will improve solder voids??
Electronics Forum | Wed Feb 20 07:31:59 EST 2008 | davef
We'd go with the formula above.
Electronics Forum | Tue Feb 19 22:57:38 EST 2008 | davef
Duno. What's the diameter of: * Finished connector lead * Finished through hole We reckon: Lead size plus ~0.25mm [0.010"] is normal.
Electronics Forum | Tue Feb 19 23:00:29 EST 2008 | amarpreet41
Connector pin - 10.83 mils Hole dia - 27 - 33 mils. We are trying to find the optimam level for hole dia.
Electronics Forum | Wed Feb 20 09:05:38 EST 2008 | tonyamenson
We had a similar problem with lead-free through-hole components. We baked those baords to remove the residual moisture and everything went to 100% pass - defect was gone. Couldnt hurt to try a sample run while you decide if the PCB holes need to be
Electronics Forum | Wed Feb 20 09:29:19 EST 2008 | mun4o
ni, I had similar problem too.I bake PCB in SW mashine - about 8h ,T=90 C.Problem is in the base material of PCB - there are moisture in the material.After my complaint to PCB factory , they change material and the problem disappear.
Electronics Forum | Wed May 06 04:31:42 EDT 2009 | radzi
We have prob Solder voids for Connector, Micro D. We used HMP solder wire and pcb thickness is 0.093".
Electronics Forum | Thu Aug 22 09:09:42 EDT 2002 | 11878525
Hello Dimitry, EWI has been in the contract manufacturing business for 19 years. We're loacated in the metro Orlando (Florida) area. Currently running 3 fully automated SMT lines with PTH support lines. Would be interested in discussing your requirem
.gif)
winsouce.jpg)