Electronics Forum | Mon Mar 21 10:40:33 EST 2005 | emeto
Hello all, Can you tell me what standart is used for communication between machines in production line. I don't mean SMEMA. There is a standart for machine communication, they can communicate one with another. That is the way for example AOI says th
Electronics Forum | Mon Mar 21 23:05:19 EST 2005 | pmd
Software driven RS-232 interface. machines must have compatable software.
Electronics Forum | Wed Mar 23 02:51:50 EST 2005 | Base
Hi Evtimov, Try to stay away from GEM or SECS/GEM. It's waaaayyyy to complicated and every vendor has there own interpretation of it when it comes to events and reports that are not commonplace in the semiconductor industry, which is where the GEM-s
Electronics Forum | Fri Jun 04 13:23:54 EDT 2010 | mmjm_1099
For the machines that are similar I would start by making sure the model name and machine name are different. The machine type can be the same but you need to add a different sufix at the end or something. See if this helps and should be able to do s
Electronics Forum | Tue Mar 30 12:18:22 EDT 2021 | chicagoindustrial
Sorry for such a generic response, but you should consider SPI if you are not happy with the results of your printer. That is probably measured by defects at the AOI. SPI machines are quite expensive. I don't see the point of them when you can just b
Electronics Forum | Wed May 26 05:58:50 EDT 2010 | chrislyttle
Hi, first time posting on here. We've recently acquired additional Fuji machines to add to our line and have moved premises to a new factory. I've been trying to set up a new factory line in Line Editor to use two of our existing machines (Fuji GSP
Electronics Forum | Thu Oct 11 12:37:27 EDT 2007 | slthomas
We purchased a used machine and can't get the block fiducial function to work properly (PCB fids work fine). I can teach them and the machine will use them but the correction is worthless. We first tried it on a 2x2 panel where the top two boards wer
Electronics Forum | Thu Oct 11 17:32:59 EDT 2007 | wayne123
In Block repeat information did you put the rotation in before optomizing? This is where the machine gets the rotation of these individual boards. The Block fiducials are good to use, but they aren't for defining rotation. If you optomized using note
Electronics Forum | Thu Sep 01 11:45:48 EDT 2011 | emeto
You can bet it was a conspiracy. Customers don't usually chew the PC boards inside their TVs,coffee machines or other electronic equipment. And if Lead is so dangerous why do we still run it and we still have to talk about problems about Lead. An
Electronics Forum | Thu Oct 11 16:55:26 EDT 2007 | slthomas
Yeah, James, we've got block repeats set up so we're getting the boards built with just pcb fids, and very accurately. I want to be able to build with block fids, though, in case we have any issues with the panelization. It's happened in the past a
