Electronics Forum | Mon Oct 08 14:48:54 EDT 2018 | tey422
Need help on how to fix or temporary fix to bypass the "Rear feeder bank in lower position" error for the Juki 2080 machine. Even replace with different feeder bank won't fix. Any suggestions?
Electronics Forum | Wed Jul 27 05:31:09 EDT 2022 | lindsaylbb
Aluminum shreds were found inside the tooling hole after depaneling. We ruled out contamination because the tooling holes were covered during depaneling. Out of three holes, only 2 holes with positioning columns inside have aluminum shreds residue.
Electronics Forum | Thu Jun 16 22:18:35 EDT 2005 | davef
Cooling may require muff fans positioned over that output conveyor of the oven.
Electronics Forum | Fri Mar 11 11:40:23 EST 2005 | JB
If there is an empty pocket at the pick up position, because a component "fell off" then the pick and place machine will attempt to pick up more components from the same feeder an "x" amount of times, depending on your component parameters, then it w
Electronics Forum | Tue May 06 11:14:40 EDT 2003 | k_h
Sorry, I did misunderstand. My opinion would be: Assuming nothing else used feeder space, like tray changers, camera's, nozzles, ..... and assuming 1 slot = 1 8mm feeder position, I think 70-90 slots would be reasonable. A reasonably priced feeder ta
Electronics Forum | Fri Jul 17 07:50:32 EDT 2009 | csm
Dear Jepoy We check the oilmatic system and I found a relay is not working, it will arrive until tomorrow. We still have 2 errors and 1 message, we are taking time because we don't have the Fuji CP6-4000 manuals or electric diagrams. we get this ma
Electronics Forum | Tue Jan 29 13:06:40 EST 2002 | Sergio Vito - Alan Patrick - Cristiano Dick
Dear sirs, We are experiencing problems with lines of lead formed inside the solder joint. In others words, there is a problem with the formation of the solder joint, after analyses on a microscope we can see the lead grouped in some positions. This
Electronics Forum | Fri Feb 23 08:51:38 EST 2007 | dekhead
Are you saying that it works in "no fmi" mode, but not in manual? Please tell me how it works in both. I'm asking you to change things to ascertain the problem, not as possible solution... if you can't get the board to stop in the correct position,
Electronics Forum | Thu Feb 22 20:17:34 EST 2007 | dekhead
My guess from your description is that you're talking about the board at stop sensor (mounted on camera) that is seeing the board, but the board edge is not hitting the stopper. Either the board stop is not extending fully, or the board is sagging an
Electronics Forum | Fri Jul 17 19:43:20 EDT 2009 | fujiphil
Have you eliminated the hardware N.G.? Check the connection for the rear door. If the connection are ok, try to bypass the key. short the two wires for the rear door. If the rear door problem is corrected, check the rear door switch physically. Reg
