Electronics Forum | Tue Nov 23 19:00:30 EST 1999 | armin
I've got a 100mm X 70 mm Dense PCB...The via holes used is 1.0 mm some are under SOIC's ...what problems that this type of via design poses ? all ideas are welcome ! thanks and regards, armin
Electronics Forum | Tue Nov 23 23:42:34 EST 1999 | armin
Is there a Standard/Guidelines that (or which IPC guidelines) defines the pad edge-pad edge clearance for Various via hole and component land sizes. Also defining why Vias shouldn't be placed under discrete components.
Electronics Forum | Wed Nov 24 06:38:57 EST 1999 | carl
Hi Larry; Have you tried just to place it as a square. Or if all fails try vision 254 255. Just be carefull with this as it will place nothing if the reel runs out. Give me a call.
Electronics Forum | Tue Nov 30 14:47:34 EST 1999 | EmJay
Larry, TRy using #254 and front light the part. When you define the leads leave plenty of tolerance and use a P-Pattern of 34.
Electronics Forum | Fri Nov 19 17:18:41 EST 1999 | Wayne S.
Hello, Going to be setting up a no-clean process for thru-hole components. Any guidelines i can use. Know the basics but want to make sure i am not overlooking any steps. Thanks Wayne Sanita
Electronics Forum | Fri Nov 19 15:17:36 EST 1999 | Vahid Vatannia
I just started my new job and I noticed that the humidity on production floor (electronics) is not being controlled. I have some basic understanding of why we need to control temp & humidity. Do you know if there is any benchmarking/studies done on t
Electronics Forum | Fri Nov 19 16:52:04 EST 1999 | Dave F
From the archives try: Humidity Of Assembly Area - Chris May 11:03:24 11/04/1999
Electronics Forum | Fri Nov 19 13:05:50 EST 1999 | Jim Trent
I would like to know what MRP software packages work best for electronics contract manufacturing. If anyone could help me here it would be extremely helpful. Jim
Electronics Forum | Tue Nov 23 17:29:28 EST 1999 | Dan
Jim, Do you know what you need out of an MRP system? I may be able to help point you in the right direction. Feel free to call or email if you want more information. Dan CircuitCAM Software (215)646-5535
Electronics Forum | Tue Nov 30 16:40:36 EST 1999 | Dave F
Most MRP systems stink, because they do not understand that we buy a part made by a specific manufacturer from a distributor. They let you buy a part from a distributor, but they make it difficult to specify the distributors supplier. Ta Dave F
.gif)
