Electronics Forum | Mon May 04 06:31:50 EDT 2020 | jandon
Are you capable of doing Class 3 products? Does the design, bare PCB board and assembly meet the requirements of Class 3?
Electronics Forum | Mon May 04 10:06:49 EDT 2020 | davef
Some Class 3 customers don't want their products to be comingled in assembly processes with Class 2 products.
Electronics Forum | Fri Apr 17 22:30:19 EDT 2020 | smith88
IPC calls out 100% wetting to land. I need to understand why this is needed and what functionality I will lose if I have joints at 80%
Electronics Forum | Sun Apr 19 11:19:52 EDT 2020 | davef
A-610G 7.5.16 Components with Bottom Thermal Plane Terminations (D-Pak) says: 100% wetting to land in the end-joint contact area. Is that what you're asking about? Regards, David Fish [davef] Technical Editor & Customer Advocate
Electronics Forum | Thu Apr 23 08:41:31 EDT 2020 | mvargas
Hi, thank you both for answering. Unfortunately, due to volume and the components we repair it is not viable to switch to selective soldering. I already contacted TechSpray and they suggested that I switch to 2211, but I don't think it's going to ho
Electronics Forum | Tue Apr 28 07:22:46 EDT 2020 | stephendo
Are you watching for copper dissolution? At one place I was asked to check why we had no barrels with some PTH locations. It was being dissolved in the solder fountain during rework.
Electronics Forum | Fri Apr 24 17:42:04 EDT 2020 | rodrigo
I checked and the fine theta motor is spinning. Thank you so much for the help.
Electronics Forum | Tue May 05 06:21:36 EDT 2020 | richardcargill
If in doubt then set it to 400. You tend to get a bit of leeway with the assembleon power supplies. Where in the world are you ?
Electronics Forum | Sat May 09 00:03:52 EDT 2020 | compit
I don't know how in Germany, but in Poland it used to be 220V (380 for 3 phases), now it is 230V (400). Probably, after the change, no one switched the voltage to the trafo in the machine - these are old machines.
Electronics Forum | Thu Apr 30 04:54:06 EDT 2020 | gfe
Hello work staff , i have a error on Mirae CODE: 1035 Mensage says (THE TEMPERATURE OF FRONT X IS TOO HIGH! Does anyone know how I can solve this problem? Tanks ;)
