Electronics Forum | Wed Oct 10 08:41:05 EDT 2018 | bdamico
Hello Reckless, No all of our MIRTEC systems are Windows based. I look forward to meeting you in Chicago. Please provide your contact information to schedule a demonstration. My full contact informtion is available on our website: http://www.mir
Electronics Forum | Fri Oct 12 01:50:51 EDT 2018 | robl
We have a pair of old 22XDL's that are just used for heritage boards, and they do a good job. They have 5MP cameras in them same as the MV3L's. We had MV3Ls and MV5's at a previous place and got similar results. The key is understanding properly h
Electronics Forum | Wed Oct 24 07:28:36 EDT 2018 | tech1
It will in a limited fashion. It is a scanner and when using it for solder or lead inspection you will probably get many false calls, Operators tend to fall asleep clicking "accept" all the time. Don't get me wrong, we run one of these systems and it
Electronics Forum | Tue Oct 09 05:38:29 EDT 2018 | dfl
Hi, my Quad IV-c is showing a really dark image on the camera and its VERY difficult to see the components pads to make the adjusts. I already check the monitor brightness (at maximum and I can see the crosshair, so the monitor is good) and already
Electronics Forum | Tue Oct 09 10:29:47 EDT 2018 | dfl
Thanks Bob. Using a flashlight helps a lot, indeed. Is "re-adjust the angle" just a bend on the LEDs heads (by hand)? I will try. To replace de LEDs, can I use white ones? I believe with the reds I get less light than whites, but maybe the camera ne
Electronics Forum | Thu Oct 11 00:11:49 EDT 2018 | mk15
I am looking for some help for where to look to fix this MY15E problem. We started the machine after the weekend and this error code comes. F-MOT-MSETDYN z/3: Upper end point outside limit. Any suggestions? Thanks
Electronics Forum | Tue Oct 30 12:47:17 EDT 2018 | padawanlinuxero
hello try to calibrate the Z axis, check the cable must be damage, check if the transducer is loose, just some options from the top of my head, have you try getting into service and make it work there? if not try that too.
Electronics Forum | Fri Oct 12 11:21:43 EDT 2018 | tech1
There are 2-X motors and numerous items that could be causing this: 1 of the X motors, 1 of the X transducers, 1 of the couplings connecting the motor and transducer, X Kevlar Belt. If you know how to go into the service portion of the software you
Electronics Forum | Tue Oct 16 10:06:41 EDT 2018 | emeto
Hello experts, I have an assembly that goes through pretty tough sterilization on regular basis. Currently I am using a two component material in potting process. I was wondering if you can help me with material that can handle high temp and humidit
Electronics Forum | Wed Oct 17 02:04:39 EDT 2018 | robl
SCC3 has an operating temperature of 200C, as long as it is heat cured at 100C. https://www.electrolube.com/pdf/tds/044/DCA.pdf It's also a silicone so needs to be coated & cured away from anything you value. Otherwise there are plenty of PU's and
