Electronics Forum | Tue Sep 10 22:29:01 EDT 2002 | scottefiske
Many times after initially cleaning in the solvents recommended by the paste/material manufacturer, a light white haze may still be visable...try using a soft bristle brush to remove the remaining residues. By this time the residues that remain will
Electronics Forum | Thu Nov 07 13:37:26 EST 2002 | dougt
This esd safe carpet is new to me. How is the carpet tested/maintained? Are you still wearing the typical foot strap or did they sell you some other kind of footwear? Sorry for "changing the initial subject" of this post.
Electronics Forum | Mon Dec 16 15:20:29 EST 2002 | sueph
Randy, are you baking initially for surface mount? These boards I'm talking about are just thru hole, so there would not be any bake between baking for part marking and wave solder.
Electronics Forum | Mon Feb 03 10:28:21 EST 2003 | gregp
The advantages of bulk feeding vs. tape and reel are numerous. Who is currently employing bulk feeding? If you are, what is the application (HVLM, etc..)? If you are not, why not? I am leaving this question very open initially in order to recieve a
Electronics Forum | Thu May 22 12:12:23 EDT 2003 | davef
Henry are you thinking ball peen hammer? Initial questions are: * If there information there, is there a way to get the Chinese character set translated? * When did these failures occure?
Electronics Forum | Fri Aug 01 23:43:52 EDT 2003 | Yngwie
Thanks Dave, the residue appeared to be similar to fungus. First, I thought it could come from water soluble flux but, our plant only runs no-clean. So, can I concluded that this greenish "fungus" looking staff is not initiated from high hot air temp
Electronics Forum | Sat Sep 06 01:54:00 EDT 2003 | fastek
This is why it is so important to print out a copy of the machine's initial data and tape it inside the front cover. You lose memory and it's right there.
Electronics Forum | Thu Apr 29 06:32:42 EDT 2004 | ccall
hello, I am from india.. we actually manufacture electronic ballasts/chokes.. but till now the whole process is manual. We need to automize the process. What essential equipments would we require initially?? akbar
Electronics Forum | Wed Mar 30 11:06:10 EST 2005 | Curious
Grant, I'm just curious on which machine You decided on, since Your initial thread is almost a year old?
Electronics Forum | Wed Jun 02 09:21:10 EDT 2004 | James
They take the place of the tooling pins. They magnetically attach to the table. Board comes in, table raises, Red-E-Set supports the board, prints, done. You just have to do the initial setup before running. We bought 4 units for each machine. J