Electronics Forum | Mon Jan 03 14:38:42 EST 2011 | leemeyer
I had this problem awhile back and it turned out to be a problem with the computer Bios settings. The battery had gone dead and the settings were set back to the default state. Luckily I have 2 of these machines and was able to reset the Bios configu
Electronics Forum | Thu Dec 11 23:38:44 EST 2003 | liang
Thank you Stefan for your help! our machine is hs50.you are right we means components are not placed on board.we can found the part around the loctation.i found bearing is dirty.i clean it with threebond.it can work well. but i want to know the rootc
Electronics Forum | Mon Dec 15 22:05:02 EST 2003 | Sam
hi Liang, We had the same problem like you before, it happened during starts up the machine (S13) and run the production for the first or second board. We also replaced the 2/2-way microvalve of placement circuit. The problem had solved at the begini
Electronics Forum | Sat Dec 13 08:03:46 EST 2003 | Stefan Witte
The only part, which could cause component misplacement on the rotary heads of the Siplace machine is the vacuum valve. I don�t know the official name in the part catalog, but I use to name it plunger. The plunger is moved in and out by a miniature s
Electronics Forum | Sat Jun 13 09:36:46 EDT 1998 | RNLM
| Is cost an issue? I evaluated Siemens Siplace about a year ago and the price per placement was twice what Phillips Machinery has to offer. We too are a high mix/low PCb count shop. Also, Siemens has many hidden costs and the references I talked
Electronics Forum | Wed Feb 02 08:11:03 EST 2022 | openindus
Thanks for the answer. Our camera doesn't even move during USC Park initialization. I assume it's a condition which isn't met to launch the sequence, but all the sensors seems to be fine. Could you send me the log (SECSDBUG.TXT) of your machine dur
Electronics Forum | Thu Dec 30 20:48:09 EST 2021 | openindus
We acquired the machine few weeks ago and it was working fine until the printer won't initialize anymore with "USC park failed" error. It seems that the printer won't respond to "4 MAXY_SP 61,0" message. Is someone has already en
Electronics Forum | Tue Feb 01 19:02:48 EST 2022 | proceng1
USC PArk is your underside stencil cleaner. The camera pushes it back and a magnet grabs it and holds it back. Ours did this many years ago. I pulled the rear cover and initialized the machine, when the camera pushes the stencil back, grab it and
Electronics Forum | Mon May 06 16:34:20 EDT 2019 | tey422
First of all, I am not familiar with the machine you stated. But there is something you should check out. That is if the nozzle tips having solder paste stick to it or not. If nozzle tips having a fresh paste stick to it, the component might not a
Electronics Forum | Tue May 07 13:49:05 EDT 2019 | tey422
Like I stated before, I am not familiar with the machine. I can only make suggestions. If you found solder paste on the nozzle, clean it off to prevent part stuck to the nozzle tip. I would also check if the nozzle tips are being worn off; uneven we
winsouce.jpg)