Electronics Forum | Tue Dec 05 17:10:50 EST 2023 | aksaustin
Is this happening in the mornings? Are the operators allowing the machine to come up to set temperature before they run it?
Electronics Forum | Mon Feb 17 03:23:33 EST 2014 | cunningham
Does anyone have a company that can do wash profiler? I want something similar to thermal profilers like your Kik and Datapaq but obviously it needs to be water proof. I want to measure temperature and pressure from the jets as part of a weekly SPC
Electronics Forum | Wed Mar 12 09:20:53 EDT 2014 | neiderman
There are a few companies that sell the pressure senors and software to data-log and map the coverage and pressure of fluid spraying systems.However they tend to be expensive. If you would like the link please send me an email and I would be happy to
Electronics Forum | Wed Dec 06 12:37:04 EST 2023 | stephendo
We have a batch washer. When it was being installed I noticed their was some foam when testing empty. We had already ran a load previously. I asked the installer and he said that it takes very little for there to be foam.
Electronics Forum | Tue Feb 18 11:02:05 EST 2014 | cunningham
Thanks for the reply. Yes we currently have an Ionagraph setup at the bottom of the wash where we take the first board out for that day and check it for contamination. Im just wanting to get an idea if any jets are blocked and that the temperature
Electronics Forum | Tue Nov 14 18:55:16 EST 2023 | kghadiya
I relate to your problem. We face this issue sometimes. It's mostly flux from SMT, TH process or rework boards. To avoid foam in our Washer, we soak the boards in hot water for 10-15 min before running it through the washer. Or you can spray the boar
Electronics Forum | Tue Nov 14 14:08:44 EST 2023 | hhudson
Good Morning, I'm a relatively new engineer, and i've been experiencing a lot of anomalies when it comes to our inline wash. We have an Austin American Hydrojet, and no matter how many times i clean the tank, it still foams like crazy! its been happe
Electronics Forum | Thu Mar 21 09:23:35 EDT 2024 | alishakihn
Good morning! I'm sorry to hear about the anomalies you're experiencing with your inline wash. Dealing with foaming issues can be challenging, but I'll do my best to provide some suggestions to help you troubleshoot the problem. 1. Check the Water Q
Electronics Forum | Mon Feb 17 22:05:24 EST 2014 | kahrpr
I am not aware of any correlation that temperature and pressure is a good indicator of board cleanliness. You can drop a thermometer into the tank to verify the temperature. Water cleanness/Ph are more important. If you are truly worried about board
Electronics Forum | Wed Dec 13 15:19:32 EST 2023 | hhudson
It has been happening in the mornings, and we do have a weak middle element, but our temp is always above 60C. we have it set at 65C. the service manager for the machine assured us that temperature wasn't the issue. Also, our flux application for ERS
winsouce.jpg)
