Electronics Forum | Tue Jun 28 10:01:24 EDT 2005 | mskler
What is your stencil cleaning procesor.It sould not be wet after cleaning & what is room tempreture.?
Electronics Forum | Sat Jun 25 10:04:08 EDT 2005 | ktron
Hi MSK, Stencil thickness: 5mils with laser cut Smallest pitch: 20mils Underscreen cleaning frequency: 10 bds per cleaning Note: We have decreased the cleaning frequency from 10 boards to 3 bds to reduce solder bridging after printing Regards,
Electronics Forum | Sat Jun 25 09:26:43 EDT 2005 | mskler
What is stencil thickness & what is the pitch of your component.What is your cleaning processor for stencil.
Electronics Forum | Mon Jun 27 09:35:24 EDT 2005 | russ
What is the viscosity of your lead free paste vs. your lead paste?
Electronics Forum | Sat Jun 25 00:52:31 EDT 2005 | ktron
Hi all, Recently I had problem with printing the lead free solder paste, almost every board has bridging especially on the fine pitch locations. Anyway this problem never happens when we use leaded solder paste. So I would like to ask if there are a
Electronics Forum | Tue Jun 28 13:04:08 EDT 2005 | slthomas
Are you saying that increasing the frequency of cleaning to every 3 boards *reduced* bridging, or that it's just something you tried? I don't understand why that would help(in my experience it has reduced "insufficient solder" conditions but not brid
Electronics Forum | Tue Mar 15 19:17:26 EST 2005 | yoman
Thanks for your reply. We are using EKRA E4 Inline Automatic Stencil Printer. It is Capable of Automatic stencil inspection. 2D solder coverage inspection. Fix Squeegee angle at 45 degees angle. Programmable squeegee speeds and pressure, boards snap
Electronics Forum | Sun Jul 26 07:52:35 EDT 2020 | sync40
Hello to everyone, Have you ever experienced soldermask bubbles inmediately after printed the soldermask itself? (for screen printing method of LPISM). I am not talking here about blistering or any outgassing defects after exposing to high temperatu
Electronics Forum | Tue Jul 10 13:45:23 EDT 2001 | markhoch
We're stencil printing a Loctite 3614 Chipbonder adhesive, and we're using BioAct SC-10 presaturated wipes to clean the stencil after printing, without much luck. Operators are not able to remove all adhesive material left in the aperatures, and aft
Electronics Forum | Wed Jul 11 18:32:34 EDT 2001 | Darby
Mark, We print and dispense with Amicon "D 125 F". Solvent used is Electrolube "SSS", which is also used for solder paste removal/pcb cleaning for misprints and rework both manually and ultrasonically. I like it - good stuff but at $25 AU per litre i
