Electronics Forum | Thu May 30 10:31:03 EDT 2002 | robbied
Hi Yannick. This is an issue that we are just recently getting into but here is some ifo that I have gathered so far. I have seen/ used 2 different rework machines. The one we have bought is a 'PACE TF2000' which was at the lower cost end of the mar
Electronics Forum | Wed Aug 07 17:25:16 EDT 2002 | gzweig
Glenbrook Technologies has a publication in pdf format that addresses just those issues. You can get one, at no cost, by e-mailing gzweig@glenbrooktech.com and request "BGA Signature" publication.
Electronics Forum | Thu Jun 19 13:39:47 EDT 2003 | Steve
So how much clearance between components (in mm) does the Ersascope require? What if you have caps around (2-3mm from the BGA's edge) a BGA . . . is it necessary to remove them prior to inspection of the BGA?
Electronics Forum | Sat Aug 15 06:59:01 EDT 2020 | toki
Hello everyone, hope everyone is doing well. I would like to know what should i look for while purchasing an X-Ray machine for SMT production line. I am looking for offline x-ray machine and budget below 90k usd. It will be used to inspect BGA, QFN a
Electronics Forum | Wed Jun 11 16:20:41 EDT 2003 | russ
I am in agreement with Stephen. we also use the little mirror with a microscope. Russ
Electronics Forum | Wed Jun 11 11:33:07 EDT 2003 | tt
We have been looking around at all of the various BGA visual inspection systems, (i.e. ERSAscopes like contraptions). It seems like the number of different manufacturer's of these types of systems has exploded in the past couple of years, and it lo
Electronics Forum | Mon Nov 25 00:45:35 EST 2013 | igorfo
Thank you for advice, But main concern how to detect the problems with BGA on SMT line, and how I can validate "good" or "bad" profile. PS: SPC said that process Cpk 2, temperature profile in the upper spec limit for TAL and peak temperature.
Electronics Forum | Fri Jun 20 13:04:37 EDT 2003 | Pete
Why all the fuss about BGA inspection?? If your reflow process is sound and your rework system is competent (i.e a PDR) they will be fine. Best advice I can offer is to srike a deal with an outside company who will inspect a small batch of your pro
Electronics Forum | Wed Jun 18 21:28:08 EDT 2003 | Larry D
Tom: Cheapest is grind flat spot on inspection mirror. Plastic mirror is easiest and works for the 1st 2 rows.
Electronics Forum | Wed Aug 21 14:35:16 EDT 2002 | Kovachik
We are a CM located in Eastern Canada. Looking for some used X-Ray Equipment. Would anyone be able to suggest some reputable used equipment dealers, preferably in Canada OR perhaps one of the board readers'companies would have equipment they are lo
Our Company handle AOI (Auto Optical Inspection) and SPI (Solder Paste Inspection) Machines.
Equipment Dealer / Broker / Auctions
Hwaseong-si, Gyeonggi-do, Korea
Hwaseong-si, South Korea
Phone: +82-1029254936
.png)
