Electronics Forum | Mon Aug 16 18:39:21 EDT 2021 | SMTA-64387687
Utility-Installation-Hydra Tool Utility "Enable Hydra Tools"
Electronics Forum | Tue Dec 06 15:57:07 EST 2022 | robertobsuinc
I'm using 15E with tpsys software 3.1.2 and the machine is not using the hydra tools, hydra bank and tools are installed, package and components has the hydra tools, but is only using single mount.
Electronics Forum | Thu Mar 28 14:28:26 EDT 2024 | kingkelvin
We have MY9 - when it changes hydra tooltips - most of the time it makes a small "hitting" type noise - with error F-MOT MOVESLOWMOVE HYDRA Z/205 - however you can just hit continue and it will always change the tools and finish the board - I've un-i
Electronics Forum | Mon Apr 08 14:07:25 EDT 2024 | kingkelvin
Hello all - so I got in the calibrate plate for hydra tool offsets - it completed the calibration - I then installed the first row of white tips with the menu - and the machine still does same thing it puts the tips away but makes a hitting type nois
Electronics Forum | Tue Apr 02 14:56:30 EDT 2024 | kingkelvin
Hi all - my problem is a bit worse now - I can get all hydra tests to pass in extended service, except indicator levels at current 7 a bit high past 190 limit at ~210-220 - other than that hydra bank re-installs OK - but still it makes a bad hitting
Electronics Forum | Thu Feb 01 14:57:05 EST 2024 | cflames17
Have you tried reinstalling all the tools? This appears to be a problem with the tool bank being out of tolerance. Reinstall each tool in your tool bank one by one. Are the hydra tools ok?
Electronics Forum | Tue Apr 02 17:56:44 EDT 2024 | mistrthou
You'll need the specific Mydata part. It has some specific dots and square printed on it. It should be in a box with other calibration parts, stuff which we do at least every 6 months. I attached an internet picture of the box that contains the diff
Electronics Forum | Thu Oct 15 21:29:42 EDT 1998 | Scott McKee
| I need to install some new lines for high mix low volume products in an already cramp building. Could someone share any info about the machines which give you the best bang for floor space. I need a 2 machine system for placing 0402 to fine pitch,
Electronics Forum | Fri Oct 16 00:23:16 EDT 1998 | Jim McCarten
I do not think that the Mydata can pick from wafer or has the accuracy required (12 micron)! Am I missing something? | | I need to install some new lines for high mix low volume products in an already cramp building. Could someone share any info a
Electronics Forum | Fri Oct 16 21:33:51 EDT 1998 | Scott
| I do not think that the Mydata can pick from wafer or has the accuracy required (12 micron)! Am I missing something? I don't have personnal experience with flip chip but the next time you're at Nepcon ask Mydata to show you their demo board with
| 1 |
winsouce.jpg)