Electronics Forum | Sat Jul 10 22:47:38 EDT 2004 | SMT helps!
Hi Al, check out (AES) Automate Equipment Services, Inc base in Oklahoma WWW.smtsupports.com or 1-800-833-3484 Mike Baker, Steve Lewis, Marty Greene for contact. Good luck Vinnie
Electronics Forum | Sun Jul 11 22:05:05 EDT 2004 | Edward Ivey
The phone Number to Automated Equipment Service is 1-888-833-3484. You will need to talk with Mike Baker, or Marty Greene.
Electronics Forum | Tue Jul 13 21:17:03 EDT 2004 | adiaz
Vinnie, Thank you for the information, I will contact them and hope we can have a deal! Once again, thanks! Alfredo
Electronics Forum | Tue Jul 13 21:19:21 EDT 2004 | adiaz
Thank you Edward! You and Vinnie recommended the same company, it means, they are the ones to hire! Thanks again, Alfredo
Electronics Forum | Sat Jul 10 18:19:16 EDT 2004 | Alfredo Diaz
Hello All, We are in the process of setting up a SMT line and would like you guys to recommend a company who help us to do the movement, set up and alignment of the machines. Machines are MPM UP2000, Fuji CP642, Fuji IPIII, Heller 1800EXL Oven. Tha
Electronics Forum | Mon Jun 26 17:49:07 EDT 2006 | flipit
Mark, You should check the way the paper is installed. I found that the Dek265LT documentation said to install the roll one way. The rolls we were buying from JNJ Industries stated to install the paper another way. I then found that one operator
Electronics Forum | Sat Jul 14 12:01:04 EDT 2007 | clickeasi
I am looking for some who provide installation and training on IP2 in Northern Cal.
Electronics Forum | Fri Jun 28 10:51:15 EDT 2019 | robertogonçalves
Do you have the instruction manual for instalation de software to machine EKRA X4?
Electronics Forum | Tue May 29 11:59:53 EDT 2007 | leemeyer
Thanks for the info. I have installed Dos 6.22 and re-installed the SPM software. Now when I boot up I get an "invalid installation" error and the program terminates. Are there other setup issues I need to take care of.
Electronics Forum | Sat Oct 17 18:43:56 EDT 2009 | emanuel
Just a moment.... when the machine was installed I was told to use a dry air line, so it is connected to a line that passes through an air dryer and no oiling at all. Should it have oiler installed? I will check the installation manuals
.gif)
winsouce.jpg)