Electronics Forum | Wed May 29 08:43:12 EDT 2002 | zanolli
Various solder metal supplies sell pre-forms as loose individual shapes, usually donuts. The loose performs then are placed on the connector leads. If you have any volume at all, you would want to look at a �shake table� that would vibrate a batch of
Electronics Forum | Tue Jan 21 13:51:19 EST 2014 | rgduval
Armando, Is the problem in the same spot on the board with every run? If so, there might be something about that particular location that is part of the cause (ie. ground or power plane connection). It sounds like you're seeing blow holes, or insu
Electronics Forum | Thu Nov 17 21:46:48 EST 2005 | C. Kolokoy
With DIP type components, a sub-par fluxing method (foaming a no-clean), and a chip wave where one is not needed are formulas for bridging and insufficient wetting. If you have SMD's on the wave solder side of the board greater than 0603, and no SOT
Electronics Forum | Wed Jan 15 21:55:41 EST 2014 | padawanlinuxero
we do that and there's a variation on the solder temp. sometimes around 10 degrees, we have 2 solder pallets that are run in intervals of roughly 3 1/2 minutes a part (the time that take the operator to put all 3 terminals in a 42 pcbs per board, and
Electronics Forum | Thu May 26 21:09:01 EDT 2005 | thaqalain
The reliability of a Gullwing component solder joint is in question when insufficient solder is evident: *at the heel of the lead *at the toe of the lead *none of the above
Electronics Forum | Fri Apr 04 01:39:21 EDT 2008 | slthomas
All of what Dave says is spot on. I suspect that the most likely corresponding defects on your assemblies would be poor wetting and insufficient solder.
Electronics Forum | Sat Nov 07 14:05:43 EST 2009 | doremi
Hi, I have 4 years as an AOI Process Engineer and we are working with 3 types of AOI - Marantz 22X, VI3000 and Omron (RNS & VT-WIN2). For solder joint inspection (solder meniscus quality, insufficient solder, wetting problems, shorts (bridges) Omron
Electronics Forum | Fri Sep 25 16:38:56 EDT 2009 | esoderberg
empf issued an excellent study of calculated solder volume in the 90's. It used lotus 123 but is easily used in excel. I have used it for over 10 years. The only thing wrong is with leadless components. the amount of paste required generally is insuf
Electronics Forum | Thu Apr 26 11:21:26 EDT 2007 | slthomas
Question...when the machine said something was wrong, was it reading something wrong (false failure), or was there a true descrepancy but not one that resulted in a bad connection (bridge or insufficient)? Also, did you perform a DOE on the process
Electronics Forum | Tue Dec 14 10:36:42 EST 1999 | Paul Peterson
I recently encountered reflow soldering defects on a pair diode package, the smd pad had a green contamination, I'm convinced that this is not oxidation. The no-solder condition appears to be caused by a sloppy soldermask process, although over the y