Electronics Forum | Fri Jun 28 14:18:46 EDT 2013 | proceng1
I don't see any requirement for a ferrule on the wire. As long as your insulation clearance is twice the insulation diameter or less and the insulation doesn't interfere with the solder joint, it should pass Class 3.
Electronics Forum | Fri Mar 18 16:55:08 EDT 2011 | asksmt
Hi All, i am soldering battery to the back side of PCB and there are some TH Pins comes right BELOW the battery body. Can you please suggest any kind of insulating material / tape which i can use and the insulator between solder pins and battery bod
Electronics Forum | Wed Sep 25 14:40:22 EDT 2002 | Claude_Couture
McMaster.com has ceramic fiber insulation in ribbon form, p/n 87575K89. you might check this up. It is use for high temp insulation, like in furnace. Come in different thickness, width, etc...
Electronics Forum | Tue Jul 11 04:14:24 EDT 2006 | Rob
1) Use insulated wire & only strip back as much as you need for a good joint. 2) Wrap insulation tape around each joint (package lead with wire) after soldering to avoid any possibility of touching.
Electronics Forum | Fri Oct 06 01:08:17 EDT 2017 | tsvetan
potting the board with epoxy will make it non repairable the same insulation effect you would achieve if you just put around the inductors some styrofoam or other sound insulator without messing with epoxy
Electronics Forum | Thu Aug 01 11:18:06 EDT 2019 | bulur
Is TS-2414 insulating varnish material suitable for conformal coating of PCBAs? How can its performance be tested? What properties should be looked for on its data specs to conduct initial assessment if it is a suitable coating material?
Electronics Forum | Wed Feb 05 19:14:24 EST 2020 | victorzubashev
Hi all, what you can suggest using as an instant and reliable adhesion for jumper/hook up wires with PTFE insulation during SMT rework on FR4 PCBs? Cheers, Victor
Electronics Forum | Wed Mar 07 12:04:44 EST 2007 | Robbie
Have you considered replacing the insulative latex with disipative rubber matting?
Electronics Forum | Tue Jun 23 19:00:03 EDT 2009 | isd_jwendell
I don't know about removing the teflon insulation, but we weld our thermocouples.
Electronics Forum | Wed Jul 01 10:17:35 EDT 2009 | davef
So, would putting insulating pads on the test fixtures without pads make this issue go away?
