Electronics Forum | Sat Mar 24 00:08:55 EDT 2007 | mika
Fully SMPI (there are 2 kinds of SMPI and Universal used them both in the past). Converter cables between SMPI > Fully SMPI Converter cables between FUJI > Panasonic Converter cables between FUJI > SMEMA Converters between almost any machine interfac
Electronics Forum | Fri Oct 23 18:13:53 EDT 1998 | Dave f
| I am looking for detailed information on the SECS 2 protocol that is part of the SEMI General Equipment Module interface. I was not able to get detailed information from the SEMI web site and was not able to find anything on the web. | | I am look
Electronics Forum | Thu Nov 29 20:29:07 EST 2007 | b4tt1e
Thanks Jon, indeed it sounds simple from your reply. But unfortunately I'm not a mechanical engineering student :( beside, my final year project is something about motors control and sensors. My supervisor suggest me to take a look at the feeder comm
Electronics Forum | Thu Dec 04 15:18:36 EST 2008 | kmakiya
google "smema machine interface standards". This will show the cable connections and explain how the communication works. good luck
Electronics Forum | Thu Jan 13 15:08:22 EST 2022 | emeto
Hello Jeff, error is telling you exactly what it is - communication problem. CAN interface is interrupted somewhere. Motors are constantly sharing position and commands with computer over CAN interface. To get this message means somewhere this circui
Electronics Forum | Mon Oct 16 16:05:59 EDT 2000 | CAL
Brian- IPC has SMEMA Down loads for communication protocal: http://www.ipc.org/html/fsresources.htm. Also, I interfaced a fuji CP6 with a Siemens s20 and had to put in a relay and sensor to complete the communications loop. Fuji uses a 24v on/off com
Electronics Forum | Wed Jul 02 00:53:47 EDT 2008 | tsarapin
Thanks for your post Deni. As far as I know, HP300 software written in HP BASIC, it communicates with SMT machine over HPIB. We can use PCIHPIB interface card and port software to x86. SMT software is over 5000 strings in HP BASIC, most of them is a
Electronics Forum | Mon Oct 22 15:30:57 EDT 2001 | Basaran
Is there anybody in this forum who is using TI DSP 320C6203 modules for communication devices. I would like to know if anyone has problems with Solder bump- Ni pad interface delamination or problems with signal quality.? Cemal Basaran
Electronics Forum | Mon Jan 21 08:49:43 EST 2013 | cnotebaert
Sorry to keep brining up such old topic! I’m looking for some help. I have a CP4-3 that I’m getting up and running. It was last interfaced with Flexa software, however I’m looking at connecting an F4G or MCS30 to it. Does anyone know if it was upgrad
Electronics Forum | Fri Dec 30 20:12:47 EST 2022 | ttheis
I found a broken COM3 connector on the fluxer interface board where the PC comms go through and replaced the connector. Now when trying to establish communications the exhaust fan turns off briefly a few times then it times out and reports a failure