Electronics Forum | Sat Jan 29 12:01:32 EST 2011 | jts142
hi i am having problems with a cp 643 when i run in auto it errors unloading a board with the x axis servo interlock error but if i hit sequence end stop so that it stops after every board it runs and unloads perfectly. Any hints or suggestions we ha
Electronics Forum | Tue Feb 01 13:21:34 EST 2011 | cyber_wolf
Try switching to a different board and see if the error goes away. If it does, it has something to do with one of the loader sensors not being made.
Electronics Forum | Fri Feb 04 01:31:44 EST 2011 | fujiphil
Possible cause is the Middle Loading Sensor. Check the ML flag. Also, this problem occurs when the z-axis base slips. Need to level the base and re-calibrate z-axis origin.
Electronics Forum | Wed Jan 16 12:57:29 EST 2002 | Kevin Neal
Check all of the interlocks. The heaters and conveyor will not power up unless all of the interlocks are closed.
Electronics Forum | Wed Oct 16 01:02:27 EDT 2024 | lukejk95
Hello, We have a Radial 5 machine from Universal Instruments and every time I turn the Interlock Bypass key to disengage the Interlock Bypass and run at full auto, my machine will act as if a cover or an interlock is not being made. All 13 covers ar
Electronics Forum | Tue Apr 11 08:41:44 EDT 2017 | jdengler
Do you have an interlock bypass key? If you do can you reset the interlock in bypass? If you cannot, I believe there is a pico fuse on the interlock pcb in the control panel that may have blown.
Electronics Forum | Wed Apr 30 18:57:05 EDT 2008 | fastek
That's pretty funny.............change the cognex card. Jim you indeed have an interlock problem an if this is a UP-3000 which I suspect it is there are several interlocks if I recall correctly.
Electronics Forum | Thu Oct 17 13:31:03 EDT 2024 | poly
Voyager and the uic site has diagrams for the safety systems. There's often interlocks on weird stuff, like for me it was a feeder bank sensor was loose.
Electronics Forum | Thu Nov 18 14:38:59 EST 2004 | EED
There is a couple of things to check. Put the machine in diagnostics and let the chain run. You should see it run the same as you would if purging it. Sometimes the 2 hall effects at the disk do not see the disk as it turns. Check the driver board
Electronics Forum | Fri May 01 15:35:03 EDT 2020 | travishemen
I'm not sure if these are similar to our Genesis machines but if they have removable feeder banks they are part of the safety circuit. If they are not installed or if the sensors on them are misaligned it will show the same as an interlock violation
