Electronics Forum | Thu Oct 05 16:04:00 EDT 2006 | GS
I am not expert, just my comment, the total ionic contamination allowed after SMT, by using No Clean process, theoretically it should be close to Zero. Any way the Standard IPC-JSTD-001 allows 1,56 ugr NaCl/cm2 for the final Printed Board assembled.
Electronics Forum | Mon Feb 21 20:15:49 EST 2022 | arminski
since IPC-J-STD-001 RevH obsoleted the 1.56ug/cm2 UCL of ionic contamination tester in testing using ROSE test, how do you define the acceptable limit per PCB assembly? thanks
Electronics Forum | Thu May 31 11:26:33 EDT 2007 | gsala
Tnks Patrick, additional infos..... we are just playng with different NC solder wires L-F, the best results in terms of solderability (faster solder flowing, holes filling up) it seams are coming from an ROM1, as we know, according to J-STD-004, or
Electronics Forum | Sun May 09 16:25:00 EDT 2004 | gabriele
Military and most commercial standards requires > post-soldered boards to measure less than 10 > �g/in of NaCl (14 when using an Omegameter, 20 > on a Ionagraph, and 37 on a Zero-Ion). > > As Dave > stated, 6.5 �g/in of NaCl is called out in >
Electronics Forum | Thu Sep 05 22:36:38 EDT 2013 | davef
Yes, providing your: * Inbound material does not compromise your process. * Soldering processes apply the proper amount of flux and activate it properly * Material handling does not contaminate your boards Recognize that the IPC requirements of less
Electronics Forum | Wed Mar 08 14:11:38 EST 2006 | mholz
I am looking for an industry standard �stock� note to place on our printed circuit board assembly drawings that will capture a level of cleanliness for an IPC-A-610 class 2 board assembly. I�m looking for some quantitative spec for cleanliness that w
Electronics Forum | Mon Apr 15 22:37:27 EDT 2002 | davef
Regarding your customer suditor, it would have been nice if you said something like ... Routinely, our testing shall be less than 1.56 microgram/cm^2 NaCl equivalent ionic or ionizable flux residue, according to TM-650, Method 2.3.35 'Detection And
Electronics Forum | Wed Nov 17 11:20:23 EST 1999 | Dave F
Hey Gyver: If you don�t mind (which you don�t have any choice about, because I�m going to do it anyhow, cause it�s MY word processor), I�m going to respond genericly, but still be directed to your question. Much of the following is paraphrased from
Electronics Forum | Mon Jul 30 21:03:44 EDT 2001 | davef
You should specify the level of res based on the effect of the res on the end-use of the product. J-STD-001 defines cleanliness requirements for ALL flux types, including water soluble and no-clean that you mention. 1 There is no equivalency betwee
| 1 |
winsouce.jpg)
