Electronics Forum | Tue Dec 29 20:35:29 EST 2020 | davef
Alcohol Content: Ionographs don't like to have the alcohol content too far off from 75%. If that happens, either way, your resistivity will be low. Temperature: Ionographs don't like to be rushed. Stay focused on a proper warmup time. If you don't,
Electronics Forum | Mon May 02 12:03:17 EDT 2016 | dekhead
Many different units used over the years; AC (just cooling); TCU (heating and cooling) and ECU (temperature and humidity)... Let me know exactly what you've got, I'll see what I can offer for manual. www.dekhead.com
Electronics Forum | Thu Jun 08 01:52:16 EDT 2006 | ec
Hi, Is there any special temperature setting for example , bottom temp should be lower than top temp to prevent component drop. Or any information that can help to prevent component from drop off during reflow of top side.
Electronics Forum | Thu Jun 08 03:40:32 EDT 2006 | aj
Hi, I use convection reflow and both top & bottom settings are the same. Is the part too heavy to rely on surface tension? there is an equation that can determine this (aswell as real test i.e. part falling off) We have some SIM Card holders on bot
Electronics Forum | Thu Jan 26 13:13:14 EST 2017 | dyoungquist
What type of solder are you using, Lead or Lead-Free? What is the melting point of it? What temperature are you setting your solder bath to? Possible solutions: 1) Give your solder bath a little more time to even out the temperature across the en
Electronics Forum | Wed Sep 14 04:09:21 EDT 2016 | jimmyh
We are enclosing our SMT room and will control the Humidity and Temperature of the room. Is there a standard for humidity and temperature for a SMT room and if so what is it. What is protocol if it goes out of tolerance? Do we stop production? Is
Electronics Forum | Wed Oct 11 20:52:51 EDT 2006 | psgill
Guys, Any of you tried running different setting on the top & bottom side temperature on the reflow oven. I'm trying to address uBGA coplanarity issue using this method. Assume board are flat. Any inputs?
Electronics Forum | Wed Jun 12 04:02:00 EDT 2019 | liyunqiong
SMT reflow soldering temperature setting and process flow: The influence of SMT reflow process parameters on the key parameters of reflow soldering temperature curve provides reference for the setting and adjustment of reflow soldering process para
Electronics Forum | Thu Jun 08 17:21:31 EDT 2006 | PWH
EC - I hope you don't mind that I add to your question... We are running lead free assemblies now and parts that normally hang on upside down are falling off. Any advice on this from others new to lead free?
Electronics Forum | Fri Jun 09 04:21:20 EDT 2006 | rlackey
Hi EC, there was an in depth post dealing with this back in 2000 from the now legendary Bob Willis: http://www.smtnet.com//forums/index.cfm?fuseaction=view_thread&CFApp=1&Thread_ID=1468Message6342 Cheers, Rob.