Electronics Forum | Tue May 22 09:37:11 EDT 2007 | jdengler
Hi Joakim, I do not know the QP242 table, but on our GP-341, CP-IV-2 and IP-III we make a plate from plexiglass with milled holes to show where the supports go for each board. This is not as fast as the Gridlock but does not cost nearly as much. J
Electronics Forum | Tue May 16 11:10:06 EDT 2000 | Ramon I Garcia C
I don,t speak english very well but I,m trying to give my opinion. I have the same problem but with the conecctor, because I have an IP-II and it hasn,t nozzle origin, I think if "I have an IP-III; I can correct this problem" I think maybe we need t
Electronics Forum | Mon Jun 19 02:46:34 EDT 2000 | Manohar Singh
We have Fuji IP3 Machine with SMD3 Vision system. We are in an attempt to place BGA on the PCB with IP-III. The BGA is a 256 Pin, the ball size on device is minimum-25 mils, maximum-35 mils, PCB pad size is 32 mils. We don't have any specific inspect
Electronics Forum | Wed Apr 02 17:52:41 EDT 2008 | fsw
Sr. Tech, We have a IP III on one of our lines. We were hand placing an Samtec SMT connector MMT-108-01-T-DH series. I asked our SMT tech to get the IP to place it & he said we need tabs on the connector. So we got the "tab" version. Now he is not a
Electronics Forum | Mon Mar 16 07:40:06 EDT 2009 | jdengler
Hi Pete, For the price the ProSmt+ is good. I do not have much experience with F4G but do with MCS. It very easy to use with a few exceptions. The PD editor on ProSMT+ is buggy. If you copy a PD edit it and save it under a new name it's lnked so
Electronics Forum | Mon Nov 09 11:56:59 EST 1998 | Stefan W.
At least I can imagine what happens and it may solve your problem. If the vacuum is already turned on above the component there will be an airstream above and around the component. This might even suck the air out of the cavity, which supports the co
Electronics Forum | Sun Mar 18 23:01:11 EDT 2007 | diesel_1t
Hi there, I want help on the following issue. Where I work, we place a component QFP 256 terminals (20 mil pitch)from hitachi (renesas), we use a MPM UP-3000 screen printer, IP-III placement machine and Vitronics 8 zones reflow Oven. lead plating
Electronics Forum | Sat Mar 24 12:31:31 EDT 2007 | diesel_1t
Hi there. Ok, i have a little big question for fuji Erudites: when machine run out of parts on any device it tells to machine "parts out (and part number)" So, a signal from anywhere (maybe a PLC output) will tell to the machine "hey i'm out of parts
Electronics Forum | Fri Jul 15 12:15:08 EDT 2022 | aj3
Does anyone have any documentation or knowledge about the S3088-III or 3088 Basic Viscom AOI machines? I am trying to determine if I can pass the data it outputs to a 3rd party vendor, and I need to know the connection method (local network, internet
Electronics Forum | Sun Aug 26 12:40:59 EDT 2001 | stefwitt
I would like to enter the discussion by tossing some numbers in. First of all I don�t like the 3 Sigma value. 3 Sigma are 2000 defects per mio. if I remember correctly. This means, if you have 200 components on the board, then every 10 boards have on
.jpg)
