Electronics Forum | Fri Feb 27 10:31:59 EST 2015 | mdang
We bought a use IP3 and we want to make adjustment in Y direction of the MFU. Is this proper setting or Mechanical calibration? Thanks, -Michael
Electronics Forum | Thu Oct 26 07:18:47 EDT 2017 | stephendo
Once upon a time an IP3 and CP6 would shut themselves off when the room was too hot. But IIRC they simply shut down until they cooled off.
Electronics Forum | Mon Feb 01 19:45:44 EST 2021 | rodrigo
Hi all, One of the lights in head 1 (IP3) just went bad. A new one is about $150 (model 110b). Are there any replacements? LED maybe? Thanks
Electronics Forum | Tue Oct 16 01:29:11 EDT 2012 | dman97
I have a very odd problem with my Fuji IP3 and was wondering if anyone can help. Any part that gets picked from the MTU will fail vision recognition. After turning on the vision trace data, I can see that the IP3 is looking for the part to be rotat
Electronics Forum | Thu Jun 10 10:44:34 EDT 1999 | John Eramo
CP4-3 AND IP3 >CP4-3 AND IP2 >CP4-3 AND IP3 >CP4-3 AND IP2 >CP3 AND IP2 >CP3 AND IP2 Question: Looking for anyone who has this type of mix, equipment and what is your OEE and how do you come up with the numbers. I use Unicam Line monitor system to c
Electronics Forum | Sat Dec 12 12:25:14 EST 1998 | David Lombard
| My Fuji IP3 keeps getting the Check Sensor Error. | What is the problem? | This problem is caused by either of two things. First the vacuum chuck get dirty and needs to be cleaned "PM". If the problem is persistant the vacuum chick has worn down
Electronics Forum | Sat Dec 12 12:26:08 EST 1998 | David Lombard
| My Fuji IP3 keeps getting the Check Sensor Error. | What is the problem? | This problem is caused by either of two things. First the vacuum chuck get dirty and needs to be cleaned "PM". If the problem is persistant the vacuum chick has worn down
Electronics Forum | Thu Oct 29 17:43:46 EST 1998 | Guillermo Villegas
Does anybody know how to update a different nozzle than the standard one on a Fuji IP3 machine? I want to use a 15.8 mm height nozzle, but the limit on height size is 10 mm for IP3.I know, I need to use a special nozzle, so I�m trying with a 16.00 m
Electronics Forum | Thu Feb 14 21:52:56 EST 2008 | keithej2
Thanks for the reply. The IP3 we're working on is a 4400. We installed a new motor/encoder today but it didn't help. So far we've swapped the CPU, vision card, both LSOs and the servo cards. We've been poking around the relays and wiring tonight but
Electronics Forum | Fri Jul 12 12:30:56 EDT 2002 | soupatech
I just go off the phone w/ Fuji and they seem to think that the lizard tounge (used another name, same idea) is only available for the IP3. They had a few other suggestions for adapting the IP2 like a rubber pad for the carrier or building "rails" to
