Electronics Forum | Mon Aug 12 18:51:42 EDT 2002 | russ
The "BEST" thsat they could do is what is in the manual. BUT we all know that no-one that I know of designs boards with only 0805 on .100" centers with one component. CP 3 should give you on average maybe 10k per hour. IP 2 I really don't know sin
Electronics Forum | Fri Oct 15 16:52:52 EDT 2010 | wingding
Fuji IP2: I am having problems with an MTU Cycle Alarm error. There is no such error listed in the IP2 manual or the MTU manual. It sometimes comes up while placing parts on a board or sometimes right after Zero Set. Does anyone know what generates t
Electronics Forum | Fri Jul 19 10:45:55 EDT 2013 | kdc45
Have a Fuji IP-2 and the MTU has a servo alarm. There are three servo amp cards and the middle card is showing a 1 on the LED display. Does anyone know what this indicates? Also, can you tell me which axis this card is for? We do not have an advanced
Electronics Forum | Thu Feb 05 08:27:58 EST 2004 | pjc
We had a V-Tek TM30 manual taping machine using heat seal top tape. Had very good results- with skilled operator - to supply taped components to our 2x Fuji IP2 machines - no tape cropping. Stefan's points are somewhat valid, but you can have a succe
Electronics Forum | Fri May 01 13:37:32 EDT 2009 | jimmyboz
I don't have the manuals with me, so, Which axis is SA-6? Which amp displayed "7" What is "7"? 40 volt? measure across the motor power, not to grd. I think it should be 100vac
Electronics Forum | Fri Jul 19 13:50:29 EDT 2013 | kdc45
Thanks for the link, however, I have this manual already and it only shows how to replace motors, belts and prox switches and to adjust for zero set. Appreciate your time and efforts. I did find that it is an OC alarm. Thanks again. Regards, kdc45
Electronics Forum | Sat Oct 02 13:55:01 EDT 2010 | wingding
I have recently started working on FUJI IP2s and CP3s, and I need information on the MCS2 system. Anything on keyboard shortcuts or possibly where I can find any manuals on MCS2 would be helpful. And no, I don’t work in a museum.
Electronics Forum | Wed Sep 17 05:18:55 EDT 2008 | ralphspm
Our Fuji IP2 has a problem reading fiducial marks.It finds the mark(is shown on console display) but after time gives out the error statement "image display time over".It gives out an error status code of "FFFC" on the console display.Cannot find any
Electronics Forum | Fri May 01 22:22:20 EDT 2009 | rodrigo
We didn't leave them swapted. They were placed in the original position until we got the replacement. What has me puzzled is that it worked for one panel correctly. I want to answer the other posts here too ... SA-6 is for Z2 The amp showing 7 is f
Electronics Forum | Mon May 18 10:54:46 EDT 1998 | Jerry
If it's really low volume I would only invest in a stencil printer and convection reflow oven to start with. If you want to go really low budget get a manual unit such at one from Transition Automation. Make up some really good shop aids and have s
| 1 |
