Electronics Forum | Wed Mar 13 14:17:03 EST 2002 | dougt
Are these sensors the reflective type? Maybe when the board is unclamped and it goes over the sensor it is seen, and then when it is clamped (raised) it is now out of the range the sensor was set for. That should be easy to adjust. A problem I've
Electronics Forum | Fri Mar 08 12:22:18 EST 2002 | pr
Have you contacted Fuji? I believe we had the same situation a while back and (I think) it was a proper setting and not a sensor problem. A tech. can probably walk you through it over the phone. good luck, pr
Electronics Forum | Fri Mar 08 22:07:31 EST 2002 | winter
I think the reason of the problem is the sensitivity of some sensor.maybe it's the main conveyor arrival sensor .I think you can do a test , make the sensor always on, and tese.
Electronics Forum | Wed Mar 20 13:49:15 EST 2002 | cabjerk
Hi All; The following is from our Support people who worked with Fuji on the problem; Last week Luke Mittur and John Gudel were in from Fuji to address the IP3 issue outlined below. The problem ended up being that the table "up" and table "dow
Electronics Forum | Tue Mar 19 16:55:54 EST 2002 | Steve E ( Fujiamerica )
This problem happens when a dark part is placed where the main conveyer stop sensor is located.The machine does a board check ( back to loading pos ) . If a part is under the sensor it absorbs the beam and the machine thinks there�s no board. The ta
Electronics Forum | Thu Mar 07 09:03:03 EST 2002 | cabjerk
After the IP3 is stopped by any means ie. Estop, cycle stop, or machine runs out of parts, upon restart the table will go to load position, unclamp, reclamp, read the fids and then proceed as normal. The problem is that if we already have fine pitch
Electronics Forum | Sun Aug 29 11:33:38 EDT 1999 | Malcolm Montanjees
| | fuji gp, cp642e, ip3 and other | | Dear Sir, please explain what you mean by GP, are you referring to Fujiu GSP printers? if so, what models are you looking for. We have GSP3-5000 and GSP3-4000 avaiable for immedate sale at $25,000 each. FOB Nor
Electronics Forum | Fri Apr 30 07:39:54 EDT 2010 | jdengler
We do a similar part on a Fuji IP3. Set table speed to low. I do not know the QP, but if it's similar to the IP make sure the board clamp/unclamp is smooth. On our IP it got dirty and was jerking causing the board to jump a little which bounced ou
Electronics Forum | Thu Feb 24 12:48:45 EST 2000 | Larry Johnson
I have seen this problem several times on several different IP3's... When the MTU is about to pick a part from the tray, the machine will just stop. No error, just says, "producting", in green. E-stop, reset and start again, and you hear air from
Electronics Forum | Thu Feb 24 12:48:45 EST 2000 | Larry Johnson
I have seen this problem several times on several different IP3's... When the MTU is about to pick a part from the tray, the machine will just stop. No error, just says, "producting", in green. E-stop, reset and start again, and you hear air from
