Electronics Forum | Fri Mar 08 22:07:31 EST 2002 | winter
I think the reason of the problem is the sensitivity of some sensor.maybe it's the main conveyor arrival sensor .I think you can do a test , make the sensor always on, and tese.
Electronics Forum | Wed Mar 20 13:49:15 EST 2002 | cabjerk
Hi All; The following is from our Support people who worked with Fuji on the problem; Last week Luke Mittur and John Gudel were in from Fuji to address the IP3 issue outlined below. The problem ended up being that the table "up" and table "dow
Electronics Forum | Tue Mar 19 16:55:54 EST 2002 | Steve E ( Fujiamerica )
This problem happens when a dark part is placed where the main conveyer stop sensor is located.The machine does a board check ( back to loading pos ) . If a part is under the sensor it absorbs the beam and the machine thinks there�s no board. The ta
Electronics Forum | Thu Mar 07 09:03:03 EST 2002 | cabjerk
After the IP3 is stopped by any means ie. Estop, cycle stop, or machine runs out of parts, upon restart the table will go to load position, unclamp, reclamp, read the fids and then proceed as normal. The problem is that if we already have fine pitch
Electronics Forum | Sun Aug 29 11:33:38 EDT 1999 | Malcolm Montanjees
| | fuji gp, cp642e, ip3 and other | | Dear Sir, please explain what you mean by GP, are you referring to Fujiu GSP printers? if so, what models are you looking for. We have GSP3-5000 and GSP3-4000 avaiable for immedate sale at $25,000 each. FOB Nor
Electronics Forum | Fri Apr 30 07:39:54 EDT 2010 | jdengler
We do a similar part on a Fuji IP3. Set table speed to low. I do not know the QP, but if it's similar to the IP make sure the board clamp/unclamp is smooth. On our IP it got dirty and was jerking causing the board to jump a little which bounced ou
Electronics Forum | Thu Feb 24 12:48:45 EST 2000 | Larry Johnson
I have seen this problem several times on several different IP3's... When the MTU is about to pick a part from the tray, the machine will just stop. No error, just says, "producting", in green. E-stop, reset and start again, and you hear air from
Electronics Forum | Thu Feb 24 12:48:45 EST 2000 | Larry Johnson
I have seen this problem several times on several different IP3's... When the MTU is about to pick a part from the tray, the machine will just stop. No error, just says, "producting", in green. E-stop, reset and start again, and you hear air from
Electronics Forum | Fri Dec 06 09:47:31 EST 2002 | Claude_Couture
Printing: use rigid carrier plate to hold and support your flexible PCB. tooling holes in PCB to position on the plate, two-sided tape to hold PCB in place. Oven: same carrier plate, use capton tape or clamps to hold PCB in place. I believe some in
Electronics Forum | Mon Dec 20 07:09:03 EST 1999 | Christopher Lampron
Ron, The simplest way to process fexible PCB's that I have found is to use a process carrier fixture. There are companies that manufacture process carriers that are capable of holding flex through stencil, placement and reflow. The carriers are capab
