Electronics Forum | Thu Jul 12 20:20:31 EDT 2007 | seankim10
I�m having problem with PCB with 16mil thickness due to warpage. the board convex up in the middle after 1st reflow. It seams the warpage is caused by CTE mismatch between PCB and multiple TSOP's, which are covering ~80% of the bottom side board area
Electronics Forum | Tue Apr 18 12:34:15 EDT 2006 | Chunks
Outside the box: Can you retro your oven with a belt chain combo? I always order my ovens this way just in case. No pallet or carrier needed then. Can justify retro against the cost of the pallet or carrier. Two part epoxy instead of heat cure?
Electronics Forum | Mon Jun 05 22:40:40 EDT 2000 | Dean
...well, if I had Fuji in on 4 occasions and the problem is not resolved I would wonder what exactly I paid for... Here is what I would do. 1. Run the glass plate program. This will eliminate variables in your production parts and boards. Additi
Electronics Forum | Sat May 29 22:20:56 EDT 1999 | Earl Moon
| | Is it possible to place parts that do not have leadframes exposed when looking from the top side of the part such as BGA's using a Fuji IP1 with a SMD1 vision (Binary) system. I realize that the IP1 does not have front lighting but according to a
Electronics Forum | Sun May 30 11:43:23 EDT 1999 | M Cox
| | | Is it possible to place parts that do not have leadframes exposed when looking from the top side of the part such as BGA's using a Fuji IP1 with a SMD1 vision (Binary) system. I realize that the IP1 does not have front lighting but according to
Electronics Forum | Sat Oct 25 19:02:45 EDT 2003 | Gabriele
Main difference is the reel holder position and for sure the clamping pin location. Tape feeding system is different. Any way they cannot be compatible among them. Q type feeders must be used for MV Q-Type placer and K-type feeders must be used for M
Electronics Forum | Sun Mar 24 17:28:20 EDT 2013 | vikkaraja
Thanks for all the help you are giving me but I just can't put my finger on this annoying problem. I checked and recheck all sensors without much sucess against the I/O. Something I am not understand is these two followning conditions--- first one I
Electronics Forum | Sun May 30 12:33:36 EDT 1999 | Earl Moon
| | | | Is it possible to place parts that do not have leadframes exposed when looking from the top side of the part such as BGA's using a Fuji IP1 with a SMD1 vision (Binary) system. I realize that the IP1 does not have front lighting but according
Electronics Forum | Sun May 30 15:11:10 EDT 1999 | M Cox
| | | | | Is it possible to place parts that do not have leadframes exposed when looking from the top side of the part such as BGA's using a Fuji IP1 with a SMD1 vision (Binary) system. I realize that the IP1 does not have front lighting but accordin
Electronics Forum | Sun May 30 18:34:04 EDT 1999 | Earl Moon
| | | | | | Is it possible to place parts that do not have leadframes exposed when looking from the top side of the part such as BGA's using a Fuji IP1 with a SMD1 vision (Binary) system. I realize that the IP1 does not have front lighting but accord
.gif)
.png)
winsouce.jpg)