Electronics Forum | Fri Feb 27 10:31:59 EST 2015 | mdang
We bought a use IP3 and we want to make adjustment in Y direction of the MFU. Is this proper setting or Mechanical calibration? Thanks, -Michael
Electronics Forum | Sat Feb 28 09:32:24 EST 2015 | assuredtech
That would be a mechanical adjustment however I would be a little suspect about why it is off and if you did your due diligence to isolate it.
Electronics Forum | Thu Feb 19 12:22:52 EST 2015 | dman97
Hi there. I have an IP3 machine that refuses to power up the MFU cart on side 1. I have already replaced the I/O card but still no dice. Is there a relay or fuse that I need to check to get this to power up? The machine will not operate the camera
Electronics Forum | Tue Feb 24 15:32:10 EST 2015 | swiese242
Hi there. I have an IP3 machine that refuses to > power up the MFU cart on side 1. I have already > replaced the I/O card but still no dice. Is > there a relay or fuse that I need to check to get > this to power up? The machine will not operate
Electronics Forum | Thu May 18 23:22:44 EDT 2000 | Micah Newcomb
Jerry, Contact FujiAmerica and ask for their newest product Guide. Some differences are..... IP2 - SMD1 vision (back lighting only, coplanarity check optional) IP3 - SMD3 vision (back, front, coplanarity check optional) IP3 - BGA transport, I
Electronics Forum | Mon Jan 31 17:09:14 EST 2000 | John McMasters
I would assume the IP2 version is similar to the IP3. I've installed 2 of the IP3 ones and they work fine. The retro is pretty simple. Tape and reel is fine if you have the room on the MFU's, we didn't have that luxury though.
Electronics Forum | Fri May 02 16:23:06 EDT 2014 | jimmyboz
Bits 0-3, no, Bit 4, MFU2 with error parts conveyor for camera 12, Bit 5,MFU1 with error parts conveyor for camera 12. The other guy is also correct, where to discard a component is in the part data. Still checking, please reply quickly if you solve
Electronics Forum | Fri Jun 14 13:19:15 EDT 2002 | mjabure
The first question is, is this a high mix, low volume environment or vice versa? If it's the former then Kens solution is something you might want to look into. Depending on your feeder set up you might check to see if your operators have been traine
Electronics Forum | Mon Dec 18 21:23:13 EST 2006 | jgarver1
The spline shaft is bent. I have replaced a number of these over the years with the exact same symptoms. How is your placement? Your 180 degree placements should be skewed if the shaft is bent. 0 Degree placements are typically acceptable due to
