Electronics Forum | Tue Nov 15 11:14:22 EST 2011 | cyber_wolf
You will need to be more specific than that. What do you mean it went off ?
Electronics Forum | Tue Nov 15 12:46:15 EST 2011 | cyber_wolf
Seems odd that the machine would zero set if there was a sensor not being made.
Electronics Forum | Tue Nov 15 12:24:12 EST 2011 | nevercry14
Well try to run in idle n as soon as the mtu. Goes to pick up part on tray it goes down but when homing back in position doesnt flag sensor because position is off.so the sz sensor not bieng flaged. Any ideas
Electronics Forum | Mon Nov 14 16:29:34 EST 2011 | nevercry14
SZ SENSOR WENT OFF DURING SY AXIS MOVEMENT. WHAT WOULD BE THE RIGHT WAY TO FIX PROPER IS OFF.DONT HAVE ORIGINAL PROPER .
Electronics Forum | Tue Nov 15 15:40:52 EST 2011 | jdengler
Do you have any trays in the location you are trying to pick from? The Z axis should move until it detects the top of a tray. Without any trays it may not function correctly. Also some machines will need an empty tray below the tray you want to pi
Electronics Forum | Tue Nov 15 22:08:58 EST 2011 | nevercry14
Thats the odd part that i can zero set no problem just when i try to run idle the sz sensor ok when goes down but when it goes back up its not bieng retracted up so sensor stays off n eror acurs again any ideas.
Electronics Forum | Tue Jun 20 21:42:19 EDT 2023 | jdengler
The MTU has it's own proper data file. You need to send that to the MTU.
Electronics Forum | Wed Jun 21 06:10:36 EDT 2023 | madisreivik
Thanks ! I totally forgot that MTU had its own prop file, uploaded it from Flexa and now works fine.
Electronics Forum | Sat Jun 24 13:08:09 EDT 2023 | madisreivik
All is OK now. The machine was offline couple months and probably some memory battery is dead. All problems were solved after uploading prop data to IP and MTU.
Electronics Forum | Wed May 06 15:25:07 EDT 1998 | Timm Rose
FUJI has a calibration tool for measuring the tray pick possition for the IP-3 machine. The part number is QPJ-1061
.gif)
