Electronics Forum | Mon Nov 14 16:29:34 EST 2011 | nevercry14
SZ SENSOR WENT OFF DURING SY AXIS MOVEMENT. WHAT WOULD BE THE RIGHT WAY TO FIX PROPER IS OFF.DONT HAVE ORIGINAL PROPER .
Electronics Forum | Thu Oct 29 17:43:46 EST 1998 | Guillermo Villegas
Does anybody know how to update a different nozzle than the standard one on a Fuji IP3 machine? I want to use a 15.8 mm height nozzle, but the limit on height size is 10 mm for IP3.I know, I need to use a special nozzle, so I�m trying with a 16.00 m
Electronics Forum | Mon Aug 23 16:28:14 EDT 2021 | rodrigo
Hi all, One of our Fuji IP3 (we have two) keeps losing the proper data (proper, status, programs) when off for a couple of days or so. I changed the battery on the MP board (its voltage looked fine: 3.6v) but that didn't fixed it. I notice a super ca
Electronics Forum | Tue Aug 24 19:32:16 EDT 2021 | jdengler
I would start there. Swap MP boards between the 2 machines to see if the problem follows. If that doesn't change anything then try the SCSI board, you can continue until the problem moves to id the bad board.
Electronics Forum | Wed Aug 25 21:41:12 EDT 2021 | same problem
I'm having same problem with one of my CP-642s. We checked cards and now the monitors are not turning on.
Electronics Forum | Fri Oct 30 18:47:19 EST 1998 | phillip hunter
| Does anybody know how to update a different nozzle than the standard one on a Fuji IP3 machine? | | I want to use a 15.8 mm height nozzle, but the limit on height size is 10 mm for IP3.I know, I need to use a special nozzle, so I�m trying with a 1
Electronics Forum | Mon May 04 22:42:46 EDT 1998 | Phillipf Hunter
Okay, Fuji MTU4 experts...I need a precise way to determin the X-origin and Y-origin of the tray plates. The center of the S-nozzle referenced to the plate corner is very difficult to EXACTLY measure. I need accuracy to pick small QFP28's - otherwi
Electronics Forum | Wed May 06 15:25:07 EDT 1998 | Timm Rose
FUJI has a calibration tool for measuring the tray pick possition for the IP-3 machine. The part number is QPJ-1061
Electronics Forum | Fri Jul 24 16:33:45 EDT 2015 | cnotebaert
You should be fine! best practice for a situation like this would be to run a solder sample, either flux it and run through wave, or screen print, don't place parts and run through reflow. look for proper wetting characteristics if you see de-wetting
Electronics Forum | Tue Jun 20 19:12:41 EDT 2023 | madisreivik
Hello all ! FUJI IP3 starts up, makes zero setting OK But if I start AUTO mode, it gives error -------------------------------------------------------------------------------- Code 11082010 UsedBy MTU3,MTU4,MTU5 Display Usable Proper Data has
